User Account

All Pages

Voltage gain of the basic amplifier

Assignment Help Electrical Engineering
Reference no: EM131085145

An amplifier with an open-circuit voltage gain of -1000 and an output resistance of 100 Ω feeds a resistive load of 900 Ω. Negative feedback is provided by connection of a resistive voltage divider across the output and one-fiftieth of the output voltage fed back in series
with the input signal. Determine the voltage gain with feedback. What percentage change in the voltage gain with feedback would be produced by a 50 per cent change in the voltage gain of the basic amplifier due to a change in the load? The loading effect of the feedback network can be neglected.

Reference no: EM131085145

Questions Cloud

Competitive markets changed the efficiency of these markets : Adam Smith, usually referred to as the father of economics, expounded the theory of free markets and opposed any form of concentration of economic power. What are some of the reasons for this failure? Has government intervention into competitive mark..
Minimum values for the stabilized load voltage : A stabilization circuit has a stability factor of 0.04 and an internal resistance of 5 Ω. The unstabilized voltage can vary between 75 and 100 V, and the load current can vary from 40 to 80 mA. Determine the maximum and minimum values for the stabil..
Determine the current-voltage and power gains : The input signal consists of an e.m.f. of 60 mV from a source of internal resistance 2.2 kΩ, and the total load on the stage output is 4 kΩ. Determine the current, voltage and power gains of the amplifier stage.
Two technologies for producing output : You are the manager of a new firm that can choose between two technologies for producing output using only labor. Technology A can produce two units of output for each hour of labor input. Technology B can produce three units of output for each hour ..
Voltage gain of the basic amplifier : What percentage change in the voltage gain with feedback would be produced by a 50 per cent change in the voltage gain of the basic amplifier due to a change in the load? The loading effect of the feedback network can be neglected.
Find a maximum flow in the network : Find a maximum flow in the network below from the source S to the sink T. Justify that your flow is a maximum flow
Problem regarding the three-phase load : The transformer supplies a 400 V feeder of resistance 0.01 Ω/ph and reactance j0.005 Ω/ph. If VR, the receiving-end voltage, is 400 V, calculate VS, the sending-end voltage, when the three-phase load delivered is 250 kW at unity power factor.
What is the annual electricity output : Domestic waste releases 9 GJ/tonne when burned in electricity from waste plant having a conversion efficiency of 25 per cent. A community of 15 000 households produces 12 000 tonnes of combustible waste annually. (a) What is the annual electricity..
Retain the ability to have an independent monetary policy : Suppose that Malaysia wants a stable exchange rate with respect to the dollar, and also wants to retain the ability to have an independent monetary policy. Are these goals consistent? What measures will Malaysia have to take so that it can achieve th..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Speed when the armature

A DC shunt motor connected to a 120-v line runs at a speed of 1200 rpm when the armature current is 18A. The armature resistance is .1 ohms. Assuming constant field flux, what is the speed when the armature is 50A?(Hint : Speed is directly porport..

  Design half-wave rectifier power supply to deliver avg volt

Design a half-wave rectifier power supply to deliver an average voltage of 9V with a peak to peak ripple of 2V to a load. The average load current is 100mA. Assume that ideal diodes and 60Hz. ac voltage sources of any amplitudes needed are avail..

  Design a signal conditioning circuit using op amps

A wind speed sensor generates an output voltage that ranges between 10 to 55 mV when the wind speed varies from 0 to 120Km/Hr.The output of the sensor is connected to an Analog to Digital Converter (ADC) through a signal conditioning circuit.

  Find the distance the sled moves before it stops

A sled of mass m is given a kick on a frozen pond. The kick imparts to it an initial speed of 1.60 m/s. The coefficient of kinetic friction between sled and ice is 0.110. Use energy considerations to find the distance the sled moves before it stop..

  Determine the frequency and the period of x

a. Determine the frequency and the period of x(t) b. Given another signal, y(t)= sin(3/4(t+1)+3/8), is y(t) identical to x(t) Why c. Given a discrete time signal x[n] = cos(3/4(n+1/2)+1/4) is it periodic Why

  Define in words how the display on the spectrum

The waveform output by the signal generator in part (b) is changed so that the rectangular pulses have the same width but no longer are periodic. They occur at random intervals of time. Explain in words how the display on the spectrum screen would..

  Create a program using asmide

Create a program using AsmIDE, which utilizes the Fox 11 68HC11 microcontroller board: Speech timer where max time is 5 minutes Use the switches for:

  What caused the blackout and any governmental regulations

Write a 500 - 550 word essay on the blackout, what caused the blackout, and any governmental regulations that were a result of the blackout and report. Reference at least one source in addition to the report, and format according to APA standard..

  How many liters of chlorine gas can be obtained at 40c

How many liters of chlorine gas, Cl2, can be obtained at 40C and787 mmHg from 9.41 g of hydrogen chloride, HCl, according to the following equation 2KMnO4(s) + 16HCl(aq) à 8H2O(l) 2KCl(aq) 2MnCl2(aq) + 5Cl(g)

  Make plots of the two triangular waves

For the purposes of the plot you may as well take the speed c, the height of the triangle at time 0, and the half width of the base all equal to 1. Make your plots for lots of times ranging from t = -4 to 4.

  Light-emitting diodes and dot matrix vs. 7-segment display

Light-emitting diodes - Dot Matrix VS. 7-segment Display - Why used Led dot matrix?

  What will the value of the current source be in ma

A voltage source Vs = 10 V is in series with a resistor of 10 kOhm. If the source transformation theorem is applied, what will the value of the current source be in mA

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd