Using continuity momentum and energy equations along with

Assignment Help Mechanical Engineering
Reference no: EM13637639

Two streams of air mix in a constant-area mixing tube, the primary stream enters the mixing tube at station 1 with a velcoity of 300m/s and temperature of 900K. the secondary stream enters with velocity of 30m/s and temperature of 300K. the flow at station 1 and 2 may be assumed one-dimension. Pressure at at station 1 is 0.1MPA. the ratio of primary to secondary flow areas at station 1 is 1:3.

a) Using continuity, momentum, and energy equations along with perfect gas law, Show how the flow at station 2 may be determined from conditions at station 1.

Reference no: EM13637639

Questions Cloud

Why might a poor yield of cyclohexene be realized if the : why might a poor yield of cyclohexene be realized if the dehydration that you did was carried out with hcl instead
A hotel elevator ascends 200 m with a maximum speed of 52 : a hotel elevator ascends 200 m with a maximum speed of 5.2 ms. its acceleration and deceleration both have a magnitude
A radioactive isotope of phosphorous has a half-life of : a radioactive isotope of phosphorous has a half-life of 14.3days. what fraction of the initial sample of the
Two containers are at the same temperature the first : two containers are at the same temperature. the first contains gas with pressure p1 molecular mass m1 and
Using continuity momentum and energy equations along with : two streams of air mix in a constant-area mixing tube the primary stream enters the mixing tube at station 1 with a
Assuming that gasolineis pure octane c8h18 and has a : 1nbspassuming that gasolineis pure octane c8h18 and has a density of0.703 gml how many liters of co2nbspgas will be
A model rocket is launched straight upward with an initial : a model rocket is launched straight upward with an initial speed of 50.7 ms. it accelerates with a constant upward
A steam power plant is proposed to operate between a : a steam power plant is proposed to operate between a pressure of 10 kpa and 2 mpa with a maximum temperature of 400 oc.
A rock is dropped from rest from a height h above the : a rock is dropped from rest from a height h above the ground. it falls amp hits the ground with a speed of 11ms. from

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  How much error would one expect in determining the

how much error would one expect in determining the specific enthalpy by applying the incompressible-liquid

  Obtain a general relation for temperature distribution

consider a water pipe of length l17m inner radius r115cm outer radius r220cm and thermal conductivity k14wmk. heat is

  A gas turbine burns natural gas assume methane where the

a gas turbine burns natural gas assume methane where the air is supplied to the combustor at 1000 kpa 500 k and the

  The radius of the curvature of the path of the car at b is

a 1500-kg car enter an s-curve at a with a speed of 96 kmh with brakes applied to reduce the speed to 72 kmh at a

  Roast can be considered as a spherical shape and it is

a 5-lb roast initial at 70degf is placed in an oven at 350degf. you may assume the heat transfer coefficient is 2.5

  What is the maximum tensile load that may be applied

a spring having a center-to-center diameter of 20 mm 0.8 in. is to be constructed of cold-drawn and annealed 316

  Saturated water vapor at 200 kpa is expanded slowly and

saturated water vapor at 200 kpa is expanded slowly and without friction i.e. internally reversibly and isothermally in

  Determine the velocity of the collars a and b

the motion of the slender 10kg rod AB is guided by collars of negligible mass that slide freely on the vertical and horizontal rods. knowing that the bar is released from rest when θ=30, determine the velocity of the collars A and B when θ = 60.

  Calculate the force required to hold the gate closed

the gate in the is hinged at H.the gate is 2 m wide and normal to the palne of the diagram.calculate the force required to hold the gate closed.

  A dam in western north carolina takes a 30 m3 s flow of

a dam in western north carolina takes a 30 m3 s flow of water from the nantahala river and diverts it to a turbine

  A gas is contained in a vertical frictionless

a gas is contained in a vertical frictionless piston-cylinder device. the piston has a mass of 4kg and a cross

  A 65 wt ni-35cu alloy is heated to temperature within the

a 65 wt ni-35cu alloy is heated to temperature within the apha liqquid-phase region. if the compostiong of the alpha

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd