Use polar coordinates to find the volume of the given solid

Assignment Help Electrical Engineering
Reference no: EM13346207

1)Use polar coordinates to find the volume of the given solid. Below the paraboloid z = 36 - 9x2 - 9y2 and above the xy-plane.
2)Use polar coordinates to find the volume of the given solid. Bounded by the paraboloid z = 9 + 2x2 + 2y2 and the plane z = 15 in the first octant.

Reference no: EM13346207

Questions Cloud

You have 100 ml of toluene total and need the extraction to : a has a partition coefficient of 3 between toluene and water with three times as much in the toluene phase. suppose
Calcium carbonate reacts with hydrochloric acid to forma a : calcium carbonate reacts with hydrochloric acid to forma a salt carbon dioxide and water. write the balanced equation
A chemist makes a solution of 133 mol cacl2 and 800 kg : a chemist makes a solution of 1.33 mol cacl2 and 800 kg water and then discovers that the freezing point of the
An airplane was moving with a velocity equal to 300mph when : an airplane was moving with a velocity equal to 300mph when the velocity was increased with uniform acceleration to
Use polar coordinates to find the volume of the given solid : 1use polar coordinates to find the volume of the given solid. below the paraboloid z 36 - 9x2 - 9y2 and above the
What is the theoretical yield of calcium carbonate if 205 : what is the theoretical yield of calcium carbonate if 2.05 grams of calcium chloride dihydrate reacts with excess
The half-life for the reaction at 550 c is 813 seconds how : the decomposition of phosphine ph3 follows first-order kinetics.4 ph3g gt p4g 6 h2gthe half-life for the reaction at
Provide the chemical reaction of an oxidation-reduction : provide the chemical reaction of an oxidation-reduction reaction that was observed to be spontaneous. provide a value
The half-lives were found to be 161 min at 199 degrees : the isomerization of methyl isocyanide ch3nc -gt ch3cn follows first-order kinetics. the half-lives were found to be

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Write a g-code to move the laser beam axis to x

A MEMS device has a pin that is to be drilled through the center. A camera is used to position a laser beam for this purpose. The center of the beam is to be retrieved using a threshold in gfilter on an intensity map.

  Derive the total response and plot it as a function of time

A serial RLC circuit is connected to a 24 DC voltage source att=0:  The output y(t) is the voltage on the capacitor one sideof which is connected to the ground. L= 1 Henry, R=2.5 Ohms and C= 1 Farad. The circuit is at restfor t

  Determine what is the power dissipated in the amplifier

An amplifier operating from a single 15-V supply provides a 12-V peak to peak sine wave signal to a 1-k ohm load and draws negligible input current from the signal source. The dc current drawn from the 15-V supply is 8mA.

  What range of values is allowed for the parameter

Suppose we have a resistive load that varies from 5 kOhms to 10 kOhms. We connect this load to an amplifier, and we need the voltage across the load to vary by less than 1 percent with variations in the load resistance.

  What is the minimum on-resistance that can be achieved

An NMOS device operating with a small drain-source voltage serves as a resistor. If the supply voltage is 1.8V, what is the minimum on-resistance that can be achieved with W/L=20

  Calculate the amount of each fuel in the mixture

For a mixture of ethane 60%, acetylene 20%, and benzene 20% total mass of 250 kg is loaded into a reactor obeying the Carnot cycle, we want to know which produces more work when reacted with 25% fuel, 60% O2, 15% CO2 for 30 cycles.

  How the packet moves from device to device through network

Imagine a network layer packet that travels from one host to another host across multiple local area networks interconnected by routers, Explain how the packet moves from device to device through the network.

  Using the rate frac12 k3 convolutional encoder create the

1.using the rate frac12 k3 convolutional encoder create the encoder. 2.using the viterbi algorithm implement the soft

  Calculate hole diffusion current density 2m from edge

in a p+-n junction, the n side has a donor concentration of 10^16 cm^-3. if ni=10^10cm^-3, the relative dielectric constant εr = 12, dn=50cm^2/s, Dp = 20cm^2/s, and the electron and hole minority carriers have lifetimes τ=100ns

  What must the bandwidth of each stage be to satisfy

A superhetrodyne receiver has three stages of IF amplification, each with a bandwidth Of 13.2 KHz. It is found that two additional stages are needed for proper operation. The bandwidth when using 5 stages must be no larger than it was using three ..

  Calculate hall voltage across the wire

An Aluminum wire with a square cross section 2mm on a side is carrying a current of 1.5amps. Aluminum has a resistivity of 2.69*10^-6 ohm-cm and an atomic volume of 10cc/mol. Assuming aluminum has three free electrons per atom

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd