Under what conditions would the other choice be better

Assignment Help Mechanical Engineering
Reference no: EM131089987

Design an EKG amplifier interface to a 9S12 (Figure 12.64). The biopotential is a ±5 mV signal measured between the left and right arms using silver-silver chloride electrodes. A third electrode is placed on the right leg and is used as a reference. To make the entire system battery-operated, low-power, rail-to-rail TLC2274 op amps will be used, each powered with +5 and ground. Notice that the analog system uses the 2.5 V signal as its reference.

Figure 12.64

2168_2203b642-1d88-4aa2-988e-1582b06a8a45.png

a) Design the preamplifier that has the following characteristics: differential input, gain = 10, good CMRR, high Zin, low Zout, bandwidth > 200 Hz. Show resistor values, but not pin numbers.

b) Show the amplifier stage that has the following characteristics: single input, gain = 250, high Zin, low Zout, bandwidth > 200 Hz. Show resistor values, but not pin numbers.

c) The signals of interest are 0.1 to 100 Hz. There is unwanted noise at 120, 240, 360, and 480 Hz. Discuss the trade-offs between the following two options:

c1) Add an active analog low-pass filter with a 100 Hz cutoff, and sample at 200 Hz.

c2) Sample at 1920 Hz and add a digital 120, 240, 360, 480 Hz reject filter.

Which approach would you take and why? Under what conditions would the other choice be better?

Reference no: EM131089987

Questions Cloud

What is its waac : The after-tax cost of dept is 6.00%, the cost of preferred is 7.50%, and the cost of common using retained earnings is 12.75%. The firm will not be issuing any new stock. What is its WAAC?
Higher after tax income the investor : The investor will invest his after tax dividend incom in ABC for five years. How much higher after tax income the investor will get in five years under the capital gains option 2 than under the dividend income option 1. (difference of option 2 inc..
Why does this state practice civil law : If DNA plus corroborating evidence is what helps put a person on death row, should they be executed if they are found sane and have been found guilty of a capital crime?
Review the goal you wanted to achieve : Explain all of the above questions as thoroughly (at least one FULL page total) as possible. Answers to the questions must be in Times New Roman 12 point font, , standard one inch margins, typed, double spaced, spell-checked, grammar-checked, and ..
Under what conditions would the other choice be better : Which approach would you take and why? Under what conditions would the other choice be better?
Identify concerns about beta and the capm : 1. Specify how risk aversion influences required rates of return. 2. Identify concerns about beta and the CAPM.
Tax differential theory of dividend policy : The tax differential theory of dividend policy typically requires that dividend income be taxed at a higher rate than capital gains income. So if the preferential treatment of capital gains that existed before 2003 is eliminated in a tax reform ac..
Designed to get someone to agree with the author : o Academic arguments are designed to get someone to agree with the author, who may use pathos (emotion), logos (logic and facts) and ethos (authority and expertise) to persuade.
What sampling rate would you choose explain your answer : What sampling rate would you choose? Explain your answer

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the mass flow rate of steam

Steam enters a diffuser at and with a velocity of and exits as saturated vapor at 240 F and 100 ft/s. The exit area of the diffuser is 1 ft2. Determine the mass flow rate of steam and the rate of entropy generation.

  Design a helical compression spring to exert a force

Design a helical compression spring to exert a force of 25 to 35 lb when compressed to a length of 2.5 to 2.0 inches (operating length)

  Reciprocating radial roller follower of a plate cam profile

The reciprocating radial roller follower of a plate cam profile with 0.7 in offset is to rise 2 in with simple harmonic motion in 180 degrees of cam rotation and return with simple harmonic motion in the remaining 180 degrees. If the roller radius is..

  If the mass flow rate of the water is 5 kgs determine the

water enters an adiabatic turbine steadily as a saturated vapor at a pressure of 5 mpa and exits at a pressure of 0.1

  Advantages and disadvantages of these opportunities

ttend a foreign study orientation session, if available, or visit your campus international center, if one available, to find out more about some opportunities that are available. List some advantages and disadvantages of these opportunities as ..

  The spring constant on car a is k 3mnm determine the

the 30-mg freight car a and 15-mg freight car b are moving toward each other with the velocities va 20 kmh to the right

  What is the entropy change of the flame

You are boiling a kettle of water over a propane stove that is supplying a uniforma amount of heat. You note that it takes 3 minutes to heat water which is initially at 20C to its boiling point. Just as the water begins to boil, you receive a phone c..

  Energy when completely combusted in air

As a 75 slug car travels along a horizontal, 3200 ft section of road, it changes speed from 5 mph to 60 mph. During this acceleration, the car gets an average MPG of 15 MPG. How efficient is the car’s engine during the acceleration assuming 1 gallon ..

  Derive a relationship between time t and the velocity v

ii. Derive a relationship between time t and the velocity V. iii. Derive a relationship between displacement D and the velocity V.

  Develop a hopscotch method for the linear convection

Derive the modified differential equation corresponding to the difference equation. Confirm that the method is consistent and compute the effective diffusivity.

  Describe the high speed machining of steel

Describe the machinability evaluation criteria, is it a quantitative or qualitative evaluation and describe the High Speed Machining of Steel/Iron or Aluminium

  Find the initial volume and final volume for this process

five kilograms of water vapor initially at 160 c and 3 bar are cooled at constant pressure until the quality is 0.4.a

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd