To what temperature should the r-22 be heated to lift the

Assignment Help Mechanical Engineering

Reference no: EM13623663

R-22 in a piston/cylinder has mass 1 kg and temp. 10°C with a volume of

0.02 m3 . Initially (state 1) the piston rests on stops with the top surface open to the atmosphere, Po, so a pressure of 1600 kPa is required to lift it (state 2). Hint: v1 = v2

i) To what temperature should the R-22 be heated to lift the piston? Draw the process from initial state to lifting on P-v and T-v diagrams.

ii) If it is heated to saturated vapor find the final volume, heat transfer, and work transfer.

Reference no: EM13623663

Questions Cloud

Estimate the charge on the outside surface of a liposome of : liposomes are promising molecules in gene transfer technology because of their similarity to cell membranes and their

Assume that the 16 sample values appear to be from a : a clinical trial was conducted to test the effectiveness of the drug zipiclone for treating insomnia in older subjects.

List the forms of energy transfer involved in this system : in a rigid tank water is heated by a benson burner while being stirred by a paddle wheel. initially the internal energy

The valve is now opened and the water in both a and b : water in a pistoncylinder arrangement b is connected to a 1 m3 tank a by a line and valve. initially at state 1 the

To what temperature should the r-22 be heated to lift the : r-22 in a pistoncylinder has mass 1 kg and temp. 10degc with a volume of0.02 m3 . initially state 1 the piston rests on

The air is initially at 100 kpa and has temperature 30degc : the heaters inside a winter cabin suddenly fail. heat is lost to the outdoors the rate of 150 kjh and the electric

The frictionless piston has a mass of 16 kg heat added : the frictionless piston has a mass of 16 kg. heat added until the temperature reaches 400 celcius if the initial x is

Use z scores to determine on which exam the student : a student took two national aptitude tests. the national average and standard deviation were 675 and 150 respectively

Calculate the rate of kinetic energy of air exiting the : an electric motor powered blower is used to accelerate quiescent air 0 ms to a velocity of 10 ms at a volume flow rate

User Account

All Pages