Three-point bending test was performed on a glass specimen

Assignment Help Mechanical Engineering

Reference no: EM13718452

A three-point bending test was performed on a glass specimen having a square cross-section of 15 mm length on each edge. The specimen fractured at a load of 4770 N when the distance between the support points was 41 mm.

A second test is to be performed on another specimen of this same glass material, but one that has a circular cross-section. What minimum specimen diameter is required to ensure that fracture will not occur when a load of 3620 N is applied? Assume that the support point separation is maintained at 41 mm.

Reference no: EM13718452

Questions Cloud

Global climate change scientist predict earths atmospheric : Due to global climate change scientist predict the earth’s atmospheric temperature will increase as much as 8°F in the next 100 years. Estimate the overall energy increase [kJ] in the atmosphere this temperature rise will cause. Consider the thicknes..

Specific heat at saturation of a liquid phase of mass : Show that the specific heat at saturation of a liquid phase of mass m (defined by Cf= (deltaQ/m)dt is generally not the same as the specific heat at constant pressure of the saturated liquid.

Stress equals youngs modulus times strain : Hookes Law (Stress equals Young’s Modulus times Strain; or s=Ee) is valid for both linear tensile behaviour and torsion (or shear) as well (e.g. t=Gg). Imagine a shear test of annealed, mild steel (e.g. AISI 1020). It is sheared until it just starts ..

What is the calculated modulus in msi : Consider a one-foot long 1/16" diameter steel wire pulled to a load of 350 pounds, while stretching only 0.045" . What is the calculated modulus in msi (use three significant digits)?

Three-point bending test was performed on a glass specimen : A three-point bending test was performed on a glass specimen having a square cross-section of 15 mm length on each edge. The specimen fractured at a load of 4770 N when the distance between the support points was 41 mm.

Reduce crack length and increase tip radius : The fracture strength of glass may be increased by etching away a thin surface layer. It is believed that the etching may alter the surface crack geometry (i.e. reduce crack length and increase tip radius). Calculate the ratio of the etched and origi..

Determine temperature in celsius of equilibrium ice water : Estimate the slope dp/dt of the ice +water line using the triple point information. Specific entropy of ice at the triple point is -1221J/kgK , specific entropy of liquid water at triple point is 0.0 J/kgK. Determine therefore the temperature in Cels..

Specific heat at constant pressure of the saturated liquid : Show that the specific heat at saturation of a liquid phase of mass m (defined by Cf= (deltaQ/m)dt is generally not the same as the specific heat at constant pressure of the saturated liquid.

Same length between supports as the length of the paper roll : A paper mill processes rolls of paper having a density of 984 kg/m3. The paper roll is 1.50 m outside diameter (OD) x 22 cm inside diameter (ID) x 3.23-m long and is on a simply supported, hollow, steel shaft. Find the shaft ID needed to obtain a max..

User Account

All Pages