Three single phase two winding transformers each rated

Assignment Help Electrical Engineering
Reference no: EM13383539

Three single phase two winding transformers, each rated 400MVA, 13.8/199.2kV, with leakage reactance Xeq=0.10PU, are connected to form a three phase bank. The high voltage windings are connected in Y. A three phase load is connected on the high side and operates at 1000MVA, 0.9 lagging PF with Van=199.2kV. Determine the Van on the low voltage side if the windings are connected in a Y.

Reference no: EM13383539

Questions Cloud

A unit all for uranium has orthorombic symmetry with ab : a unit all for uranium has orthorombic symmetry with ab and c lattice parameters of 0.286 0.587 and 0.495 nm.
How many grams of sodium lactate nac3h5o3 should be added : how many grams of sodium lactate nac3h5o3 should be added to 1.00 l of 0.260 m lactic acid hc3h5o3 to form a buffer
How efficient is the extraction of tea leaves containing : how efficient is the extraction of tea leaves containing tra1.0g of caffeine with two 30-ml portions of chloroform over
Pka2688 pka3790pka41210 assume you begin with 100ml of a : consider the hypothetical tetrapotic organic acid h4org mw236gmol pka14.07 pka26.88 pka37.90pka412.10 assume you begin
Three single phase two winding transformers each rated : three single phase two winding transformers each rated 400mva 13.8199.2kv with leakage reactance xeq0.10pu are
A student had 100 l of a 100 m acid solution much to the : a student had 1.00 l of a 1.00 m acid solution. much to the surprise of the student it took 2.00 l of 1.00 m naoh
Calculate the enthalpy change delta h for this reaction per : a calorimeter contains 21.0 ml of water at 11.0 circc. when 2.50 g of rm x a substance with a molar mass of 65.0 gmol
Aluminum oxide al2o3 is a widely used industrial abrasive : aluminum oxide al2o3 is a widely used industrial abrasive corundum emery with its specific application depending on the
Compute the maximum acceptable tensile load pu on an angle : compute the maximum acceptable tensile load pu on an angle l6x4x34 when connected to both legs. the 4 in. leg contains

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the electric field intensity produced by charges

Find the electric field intensity at (0,0,75000) produced by 50,000 0.1 C charges along the x-axis spaced at 1 meter apart starting at (1,0,0) and 50,000 0.2 C chargers along the y-axis spaced at 1 meter apart starting at (0,1,0).

  Determine the resistivity of the substrate

Consider a MOS device with the following parameters: Aluminum gate, p- typ_e silicon substrate, oxide thickness of 20nm, and surface fixed oxide charge of 4x1010 cm-2 (a) Determine the doping concentration such that the threshold voltage is 0.5V.

  Estimate the total charge enclosed within the cube

a)apply gauss's law to find the total flux leaving the closed surface of the cube. b)evaluate - *D at v the center of the cube. c)estimate the total charge enclosed within the cube.

  Provide the complete table for sequence of states of counter

Consider a five bit Johnsoncounter, initialized to "00000", provide the complete table for Sequence of states of the counter dissipation of the flip-flops

  Design a digital controller that has a bandwidth of 100 hz

The read arm of a computer disk drive has the transfer function of G(s) = 1000/s^2. Design a digital controller that has a bandwidth of 100 Hz and a phase margin of 50 degrees. Use a sample rate of 6kHz.

  Calculate m assuming the area of the coil

A 60-turn coil carries a current of 2A and lies in the plane x + 2y- 5z = 12 such that the magnetic moment m of  the coil is directed away from the origin. Calculate m, assuming that the area of the coil is 8cm2.

  Determine what is the max height obtained

A ball is shot into the air at 30 degress above the horizontal. It's initial Velocity is 5m/s and lands at the same height that it is launched from. How far does it travel horizontally

  What is the magnetization and what is the magnetic feild

A toroid is fille with liquid oxygen that has a magnetic susceptibility of 4*10^-3. The toroid has 2000 turns and carries a current of 15 A. Its mean radius is 20 cm, and the radius of its cross section is 8 mm. (a) What is the magnetization

  Determine the length of no 6 copper wire of temperature

No. 6 AWG copper wire has an area of 13.30mm2 and the resistivity at 200C is 1.75 x10-6 ohm-cm. Determine the length of No. 6 copper wireof the same temperature to give a resistance of 0.12 ohm.

  What is the minimum donor doping required

What is the minimum donor doping required to convert Silicon into a conductor? What is the minimum acceptor doping required to convert Silicon into a conductor?

  How to develop circuit1 and circuit 2 as sequential circuits

The pulse generator circuit accepts a 16 Hz pulse and converts the signal to a 1 Hz pulse, that is, a clock signal once every second. This signal is then used to drive a counter that controls how the lights are illuminated.

  Determine the value of the resistance and capacitance

A 60-Hz, 220-V-rms source supplies power to a load consisting of a resistance in series with a capacitance. The real power is 2000W, and the apparent power is 2500VA. Determine the value of the resistance and the value of the capacitance.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd