Solution-Thermal conductivity of the wet concrete

Thermal conductivity of the wet concrete

Assignment Help Mechanical Engineering

Reference no: EM13879963

A small dam, which may be idealized by a large slab 1.2 m thick, is to be completely poured in a short period of time. The hydration of the concrete results in the equivalent of a distributed source of constant strength of 100 W/m3. If both dam surfaces are at 16°C, determine the maximum temperature to which the concrete will be subjected, assuming steady-state condition. The thermal conductivity of the wet concrete may be taken as 0.84 W/(m K).

GIVEN

Large slab with internal heat generation
Internal heat generation rate ( qG ) = 100 W/m3
Both surface temperatures (Ts) = 16°C
Thermal conductivity (k) = 0.84 W/(m K)

ASSUMPTIONS

Steady state conditionsprevail

1241_thermal conductivity of the wet concrete.jpg

Reference no: EM13879963

Questions Cloud

Rules of hie access control : Which of the following are rules of HIE access control? (select all that apply)

Brumarch multimedia stop is a regional retailer of consumer : Brumarch MultiMedia Stop is a regional retailer of consumer electronics, with warehouses and stores located in several large cities in California. The board and top management of Brumarch are considering updating their accounting, inventory, and r..

Find the value of : You are asked to find the value of √1-cos A/1+cos A

Assume that you will be giving a presentation : Assume that you will be giving a presentation to the board members on their responsibilities for IT systems. Write a report that could be delivered to the board.

Thermal conductivity of the wet concrete : A small dam, which may be idealized by a large slab 1.2 m thick, is to be completely poured in a short period of time. The hydration of the concrete results in the equivalent of a distributed source of constant strength of 100 W/m3.

Describe these four methods and how they differ : There are four methods of system conversion: parallel, direct cutover, pilot, and phase in. Describe these four methods and how they differ.

Briefly describes the one positive impact and one negative : Provide a paragraph that briefly describes the one positive impact and one negative impact

Maximum temperature in the chip : For the conditions shown on the sketch, will the maximum temperature in the chip exceed 85°C, the maximum allowable operating temperature set by industry standards? A grid spacing of 3 mm is suggested.

Describe the differences between these two feasibility : Two feasibility studies occur during the SDLC: one during systems planning, and one during systems design. Describe the differences between these two feasibility studies.

User Account

All Pages

Thermal conductivity of the wet concrete

Reference no: EM13879963

Reference no: EM13879963

Questions Cloud

Reviews

Write a Review

Mechanical Engineering Questions & Answers

Compute the average acceleration of the air force fighter

The upper surface of a 50-cm-thick solid plate k237 wmk is

Head space under slight vacuum-piped to natural gas boiler

If the speed of the particle is constant v v0 determine

Gve the state temperature pressure quality if applicable

Determine the force required to pull the wedge out

Determine an expression for the ratio of the heat transfer

A well-insulated rigid tank contains 5 kg of a saturated

Determine the percent error in using the ideal gas model

Steam leaves the boiler and enters the turbine as a

This pinion runs at a speed of 1200 revmin and transmits 15

Blended mass and starch-protein ratios

Assured A++ Grade

Academics

Major Subjects

Majors

Get In Touch

TERMS & POLICIES

HELP & SUPPORT