User Account

All Pages

The mark for water has risen 06 cm above the liquid-air

Assignment Help Mechanical Engineering
Reference no: EM13639185

The density of a liquid is to be determined by an old 1cm diameter cylindrical hydrometer whose division marks are completely wiped out. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into other liquid, and it is observed that the mark for water has risen 0.6 cm above the liquid-air interface. If the height of original water mark is 13.6 cm, determine the density of the liquid.

Reference no: EM13639185

Questions Cloud

As the water jet hits the plate it begins to move due to : a constant velocity 20msec horizontal water jet from a stationary nozzle exit area 0.5 msec impinges normally on a
Use the kinetic-molecular theory to explain what happens as : 1. use the kinetic-molecular theory to explain what happens as anunknown solid is heated from below its freezing point
Fred got into his motorboat and motored for 125 km at a : fred got into his motorboat and motored for 12.5 km at a bearing of 30 degrees north of east. he then abruptly made a
Determine a the total force hydrostatic atmosphere acting : the water in a 25 m deep reservoir is kept inside by a 150 m wide wall whose cross section is an equilateral triangle.
The mark for water has risen 06 cm above the liquid-air : the density of a liquid is to be determined by an old 1cm diameter cylindrical hydrometer whose division marks are
What must the total molarity of solutes if the sap rises : a tree is exactly 10 m tall.a what must the total molarity of solutes if the sap rises tothe top of the tree by osmotic
Find the t-value with n 30 having area 005 to its : find the t-value with n 30 having area 0.05 to its
The monthly earnings of a group of business students are : the monthly earnings of a group of business students are normally distributed with a standard deviation of 594. a
During a circus performance a 712-kg human cannonball is : during a circus performance a 71.2-kg human cannonball is shot out of a 16.8-m-long cannon. if the human cannonball

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  025 kg of red-hot 700 c coals are taken from the fireplace

0.25 kg of red-hot 700 c coals are taken from the fireplace and left in the middle of a room. the room is 3 m x 4 m x

  Assume the specific gravity of solids as 267 also determine

earth is required to be excavated from borrow pits for building an embankment. the wet unit weight of undisturbed soil

  Calculate the net heat flow and the overall change

The piston is then move in,and heat is rejected bt the air reversibly at constant pressure until the volume is the same as it was initially.Calculate the net heat flow and the overall change of entropy.sketch the process of p-V and T-s diagram.

  A piston- cylinder assembly with initial volume of 80

a piston- cylinder assembly with initial volume of 80 liters contains 4kg of r-134a at a pressure of 160 kpa state 1.

  What is the maximum pressure on her hand what would be the

a person holds her hand out of an open car window while the car drives through still air at 87 mph. a under standard

  Determine the compressor work input required to compress

determine the compressor work input requireed to compress steam isentropically from 100 kpa to 1 mpa assuming that the

  Is the heat exchanger operating in a parallel flow or in a

the hot and cold inlet temperatures to a concentric tube heat exchanger are thi 200degc tci 100degc respectively.

  Calculate the true stress and strain

If the rod experienced 28% uniform strain, calculated the load at the onset of necking.

  The temperature of the water is 50 f determine the darcy

flow and pressure measurements are used to estimate the friction factor for a pipeline. the length of the pipeline

  Consider steady flow of a constant-property fluid in a long

consider steady flow of a constant-property fluid in a long duct formed by two parallel planes. consider a point

  Determine the systems coefficient of performance the power

an ideal vapor compression refrigeration cycle that uses r-134a maintains a pressure in the condenser of 1000kpa and

  Design 2-shell pass and 8-tube pass heat exchanger for

design 2-shell pass and 8-tube pass heat exchanger for heating ethyl alcohol from 25degc to 70degc at a rate of 2.9

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd