The corona wires are charged at 240 kv and the maximum

Assignment Help Mechanical Engineering
Reference no: EM13640940

A wire-plate electrostatic precipitator (ESP), designed for a commercial application for removing atmospheric particles, operates steadily with a flow rate equal to 1500 m3/h. The ESP is made up of 17 plates, each (1m x 1.5 m) with 10 cm spacing between the plates. The corona wires are charged at 24.0 kV, and the maximum electrical field is 450,000 V/m. estimate the ESP efficiency, assuming that the average electrical drift velocity is equal to 2.91 cm/s.

Reference no: EM13640940

Questions Cloud

The propeller of an toy airplace is at rest when the : the propeller of an toy airplace is at rest when the controller starts the engine. two seconds later the propeller is
A machine that cuts corks for wine bottles operates in such : 1. a machine that cuts corks for wine bottles operates in such a way that the distribution of the diameter of the corks
The particle is allowed to fall into a small hole into the : a small electrically charged particle of mass m4.0 kg experiences a force of 2.0 n if placed just outside a uniformly
What a friedel crafts acylationmechanism would look like : what a friedel crafts acylationmechanism would look like using acetic anhydride as the source of the acyl
The corona wires are charged at 240 kv and the maximum : a wire-plate electrostatic precipitator esp designed for a commercial application for removing atmospheric particles
For a binomial probability function with p 04 and n 20 : for a binomial probability function with p 0.4 and n 20 find the probability that the number of successes is equal to
How does a carbocation rearrangment result in a 6 member : how does a carbocation rearrangment result in a 6 member edring collapsing into a 5 membered ring in a reaction such as
Evaluate this design and recommend whether to proceed with : a regenerative thermal oxidizer rto is to be designed to incinerate toluene from a manufacturing process waste stream
Draw on this diagram a line expressing all the events : consider a fixed and a moving system with their clocks synchronized and their origins aligned at tt0. a draw on a

Reviews

Write a Review

 

Mechanical Engineering Questions & Answers

  Find the specific volume of steam in m3kg at 25 mpa and

find the specific volume of steam in m3kg at 2.5 mpa and 283 degrees c. what is the value predicted by the ideal gas

  Compare calculated tensile stress with allowable tensile

a 120-in long annealed rod with a cross-section area of 0.86 in2 extruded from 5083 aluminum alloy has been axially

  A fine copper wire007-cm diameter is initially heated to

a fine copper wire0.07-cm diameter is initially heated to 175c. the wire is suddenly exposed to an environment at 40c

  Assume steady-state use k 14 wm-k sketch the steady-state

a 30 m x 30 m concrete floor slab is heated by 0.025 m diameter hot water pipes sunk beneath the floor surface and

  The inner and outer glasses of a 12-m x 12-m double pane

the inner and outer glasses of a 1.2-m x 1.2-m double pane window are at 150c and 90c respectively. if the 6-mm space

  The top dead center is 14 percent of the bottom dead center

a six cylinder four stroke spark ignition engine operating on the ideal otto cycle takes in air at 1 atm and 18 oc and

  The intention is to draw air from the receiver during the

a stoped out area with a volume of 20000 m3 is to be used as a receiver. it is to be charged to an absolute pressure of

  What is the net heat flux from the surface when solar

in space ships heat rejection to the surroundings is by radiation. a radiator in a space ship has an absorptivity alpha

  Determine heat flow heat flow through a uniform wall

Determine heat flow, Heat flow through a uniform wall will: a) increase as the thermal resistance increases b) increase as the thickness of the wall increases

  The refrigerant leaves the condenser at 07 mpa 26 degc

consider a non-ideal vapor-compression cycle where refrigerant 134a flows at a rate of 0.05 kgs. the refrigerant enters

  How would you define a system to determine the temperature

a how would you define a system to determine the temperature rise created in a lake when a portion of its water is used

  A water cooled spherical object of diameter 10 mm and

a water cooled spherical object of diameter 10 mm and emissivity 0.9 is maintained at 4000c. what is the net transfer

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd