The can diameter and height are d 65 mm and h 120 mm the

Assignment Help Mechanical Engineering
Reference no: EM13345784

A partially full can of soft drink is placed at the outer edge of a child's merry-go-round, located R = 1.5 m from the axis of rotation. The can diameter and height are D = 65 mm and H = 120 mm. The can is half-full of soda, with specific gravity SG = 1.06. Assume rigid body motion.
A. Find the slope of the liquid surface in the can if the merry-go-round spins at 0.3 revolution per second.
B. Find the spin rate at which the can would spill, assuming no slippage between the can bottom and the merry-go-round. 

Reference no: EM13345784

Questions Cloud

Assume that a reaction takes place at 295 k and 305 k what : assume that a reaction takes place at 295 k and 305 k. what must the activation energy be for the rate constant to
An astronaut drops an object from rest relative to the : an astronaut drops an object from rest relative to the planet on a planet alpha having the same radius as of earth
A gas occupying a volume of 810 ml at a pressure of 0970 : a gas occupying a volume of 810. ml at a pressure of 0.970 atm is allowed to expand at constant temperature until its
The dry ice is allowed to sublime and the mixture is : a 1.30 gram sample of dry ice is added to a 755ml flask containing nitrogen gas at a temperature of 25.0 degrees
The can diameter and height are d 65 mm and h 120 mm the : a partially full can of soft drink is placed at the outer edge of a childs merry-go-round located r 1.5 m from the
If the molar mass of the hydrocarbon is 1263 gmol what is : if the molar mass of the hydrocarbon is 126.3 gmol what is the molecular formula of the
The decomposition of n2o to n2 and o2 is a first order : the decomposition of n2o to n2 and o2 is a first order reaction. at 730 degrees celcius the half-life of the reaction
Consider a sinusoidal wave with frequency of 300khz as a : consider a sinusoidal wave with frequency of 300khz as a carrier signal. we want to transmit a sinusoidal signal with
A sample of oxygen gas is collected over water at 25 : a sample of oxygen gas is collected over water at 25 degrees c and a total pressure of 637 torr. the volume of the gas

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  How many times more ignition energy is required

How many times more ignition energy is required to achieve ignition of a fuel-air mixture at sea level with T = 298 K than at altitude of 6000 m where pressure P = 47,166 Pa and T = 248 K?

  Apply the conservation of mass principle to doteed control

consider the constant -property steady laminar flow illustrated in fig 2p-4 a fluid flow through a very long tube in

  What is the total heat loss

A vertical run of copper tubing, 5 mm in diameter and 20 cm long, carries condensation vapor at 60 °C through 27°C air. What is the total heat loss?

  Determine the resultant internal loadings

the beam ab is pin supported at a and supported by a cable BC. determine the resultant internal loadings acting on the cross section at points d and e.

  What delta v was required

A satellite changes its orbit inclined 66 degrees at 260.0 km altitude to a polar orbit at the same altitude. What Delta V was required?

  Vital information about pressure cooker

Important information about Pressure Cooker, Steam is leaving a pressure cooker whose operating pressure is 30 psi. It is observed that the amount of liquid in the cooker has decreased by 0.4 gal in 45 minutes after the steady operating conditions..

  How much heat is rejected to the cooling system

steam with 88.6% quality and a flow rate of 750 kg/s enters a condenser operating @ 75 KPa. Saturated liquid leaves the condenser. How much heat is rejected to the cooling system.

  Two slender rods of negligible weight are pin-connected at

two slender rods of negligible weight are pin-connected at a and attached to the 18-lb block b and the 80-lb block c as

  What is the amount of upsetting force

Average pressure at end of stroke? Upsetting force required at the end of the stroke? If friction is neglected, what is the amount of upsetting force?

  Compute the transit time of an electron

Consider the 2.0micrometer long GaAs device where the E-field is 5kV/cm and Mn*=.067M0. Calculate the transit time of an electron through the device if the mobility is 8000 cm^2V-s.

  Design a high pressure homogenizer for the manufacture

Design a high pressure homogenizer for the manufacture of 10^6 kg per year of salad dressing.

  Ewb project

write a reflective assessment of how you rate yourself against these competencies and Describe the main learning outcomes that this course and the EWB project have generated for you over the semester. Have any of these learning outcomes been a ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd