The amount of heat transfer during the whole process

Assignment Help Mechanical Engineering

Reference no: EM13709589

1.5 kg of air in a piston/cylinder assembly has initial temperature and pressure 27^oC and 1.5 bar respectively. Then the system is heated in constant volume to 727^oC (state 1-2) and then heated again constant pressure to 1227^oC (state 2-3). Determine the amount of heat transfer during the whole process. (Use constant specific heat, c_v=0.825 kJ/kg.K)

Reference no: EM13709589

Questions Cloud

Steam enters diffuser operating steady state with pressure : Steam enters a diffuser operating at steady state with a pressure of 14.7 psi, a temperature of 300F, and a velocity of 500ft/s. Steam exits the diffuser as a saturated vapor with negligible kinetic energy. Heat transfer occurs from the steam to its ..

Determine the exit velocity of the nitrogen : Nitrogen gas at 65kPa and 7C enters an adiabatic diffuser steadily with a velocity of 210 m/s and leaves at 119kPa and 22C. Determine the exit velocity of the nitrogen. the ratio of the inlet to exit area

What must be the surface area of the lift cylinder : A hydraulic lift must lift 7000 lbs using oil that is under pressure of 130 lbs/in^2. what must be the surface area of the lift cylinder?

Exceptional thermal-insulation properties : The thermal protection system for NASA's Space Shuttle Orbiter was effective due to its exceptional thermal-insulation properties. Calculate the heat flow (per square meter) across a 50-mm-thick ceramic tile with an outer surface temperature of 1200 ..

The amount of heat transfer during the whole process : 1.5 kg of air in a piston/cylinder assembly has initial temperature and pressure 27oC and 1.5 bar respectively. Then the system is heated in constant volume to 727oC (state 1-2) and then heated again constant pressure to 1227oC (state 2-3).Determine ..

Maximum tensile and compressive stress acting on the beam : If the built-up beam is subjected to an internal moment of 75 kn*m, determine the maximum tensile and compressive stress acting on the beam

Volcano has erupted-spewing stones-steam : A volcano has erupted, spewing stones, steam, and ash several thousand feet into the atmosphere. After some time, the particles begin to settle to the ground. Consider a nearly spherical ash particle that is 50 microns in diameter, falling in air who..

The standard atmosphere at sea level : Find the terminal velocity of an 8.5-inch-diameter sphere weighing 16 lbf falling through the following fluids under the action of gravity: (a) the standard atmosphere at sea level; (b) the standard atmosphere at 10,000 ft elevation above MSL; (c) wa..

Fluid flows through horizontal annular channel : A fluid flows through a horizontal annular channel between concentric tubes at a rate of 0.01 m3/s (the absolute roughness of each tube is 1.5 x 10-6 m). The channel (shown in the accompanying figure) has an inner diameter of 25 cm, an outer diameter..

User Account

All Pages