Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Question:
Study of a power line communications. It is strongly recommended that making it narrower and deeper rather than broader and shallower. Try to be more quantitative and analytical rather than qualitative and descriptive.
It is three pages (double-column, by following the standard IEEE journal paper format).
A comprehensive project report includes:
1) introduction to the topic.
2) survey of what has been done on the topic (we expect citations to relevant journal and conference papers), and
3) implementation in Matlab, C++, or any other simulation tool of your choice.
- Also, include Abstract.
A superheterodyning FM receiver was originally designed and built to operate in the US only. The FM broadcasting band in the US is from 87.5 MHz to 108 MHz. The intermediate frequency of the receiver is fI = 10.7 MHz. This receiver has a poor RF B..
A 10 ohm resistor carries a current of 5 amps. How much energy, in joules, will be disapated in the form of heat during a period of 6 seconds
For a circuit we would like to implement, there are two control signals: x and y. If xy = 01, an 8-bit value R is incremented by 1 and control goes to a second state. If xy = 10, R is cleared to zero and control goes from the initial state to a th..
Determine the turns required in each phase of a star connected alternator operating on an 11 kV 50 Hz system if it has a flux per pole of 0.38 Wb, pitch factor of 0.95 and breadth factor of 0.98
An input signal of 10V at 0 degrees is applied to a series RLC circuit with resistore R=100 ohm, inductor L=40 mH, and capacitor C = 0.5uF. determine what is The value of the total circuit complex impedence.
We will make the follwoing probability assumptions: When team A plays team B, the probability that team A wins is given by: P(A wins) = \(([seed(B)+3]^2)/([seed(A)+3]^2 +[seed(B)+3]^2) \)
If the first bit of the opcode is 0, then there arethree opcode bits. If the first bit of the opcode is 1 and thesecond bit of the opcode is 0, then there are six opcode bits. Ifthe first bit of the opcode is 1 and the second of the opcode is 1,th..
The binary-coded-decimal (BCD) format uses 4 bits to represent 10 decimal digits. For example, 259 in base 10 is repesented as "010 0101 101" in BCD format. A BCD incrementor adds 1 to a number in BCD format.
Although this forms PNP and NPN transistors, the bias of the regions isdesigned so the junctions are reverse biased and the electric fieldeffects on the channel are supposed to control the MOS-FETtransistors operations.
Polyethylene with ?_r = 2.25 is used as the insulating material in a lossless coaxial line with a characteristic impedance of 50 Ω. The radius of the inner conductor is 1.2 mm.
If you have 1024 samples of a discrete-time band-limited signal sampled at a rate of 100MHz. what is the time period between samples. If you take a 2048 point FFT of the sampled signal, what will be the freuqency spacing between the output samples..
a three-phase 60 hz transmission line has the following parameters r 0.25 ohmsmi x 1.0 ohmsmi and y 5.0usmi. the
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd