Specify the required diaphragm area

Assignment Help Electrical Engineering

Reference no: EM131392813

Design a system by which a control signal of 4 to 20 mA is converted into a force of 200 to 1000 N.

Use a pneumatic actuator and specify the required diaphragm area if the pressure output is to be in the range of 20 to 100 kPa. An I/P converter is available that converts 0 to 5 V into 20 to 100 kPa.

Reference no: EM131392813

Questions Cloud

Design a system by which the gears are shifted : The SCR in Figure requires a 4-V trigger. Design a system by which the gears are shifted when a CdS photocell resistance drops below 2.5 kΩ.

What is the name of the main compound in rust : What is the name of the main compound in rust? Why does the nail in tube 1 not rust? What is the purpose of the layer of oil in tube 2?

Create a dynamic presentation for your research proposal : This interactive assignment will provide you with an opportunity to create a dynamic presentation of some of the materials you are creating for your Research Proposal. This type of presentation would be used in the professional world to request In..

Design a compound reverted spur gear transmission : Design a compound, reverted, spur gear transmission which will give three shiftable ratios of +6: 1, +3.5: 1 forward and -4:1 reverse with diametral pitch of 8. Specify pitch diameters and numbers of teeth. Sketch the train to scale.

Specify the required diaphragm area : Use a pneumatic actuator and specify the required diaphragm area if the pressure output is to be in the range of 20 to 100 kPa. An I/P converter is available that converts 0 to 5 V into 20 to 100 kPa.

Government spending is more employment : A $1 increase in government spending on goods and services will have a greater impact on the equilibrium GDP than will a $1 decline in taxes because:

Find the proper valve size in inches : Find the proper valve size in inches and centimeters for pumping a liquid flow rate of 600 gal/min with a maximum pressure difference of 55 psi. The liquid specific gravity is 1.3.

Determine the required valve size in inches and centimeters : The level of water in a tank is to be controlled at 20 m, and the output flow rate is nominally through a control valve, as shown in Figure 51. Under nominal conditions, determine the required valve size in inches and centimeters.

Assume that the milk industry is competitive : Assume that the milk industry is competitive. Illustrate a long-run equilibrium using diagrams for the milk market and for a representative dairy.

User Account

All Pages