Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A calibrated RTD a = 0.0041/°C, R=306.5-ohm at 20°C, and PD= 30mW/ °C will be used to measure a critical reaction temperature. Temperature must be measured between 50 °C and 100 °C with a resolution of at least 0.1°C. Devise a signal-conditioning system that will provide an appropriate digital output to a computer. Specify the requirements on the ADC and appropriate analog signal conditioning to interface to your ADC.
A copper conductor has a dia of 0.06 in and it is 1200ft long. Assume that the current total (dc) carried is 50A. Find the total resistance of the conductor. What current density exists in it What is the dc voltage between the conductor ends
a. A WLAN uses the 1-Mbps IEEE 802.11 infrared standard and the 16-PPM modulation scheme. Compute the period of transmission (time between bits). b. What is the average time between pulses (1 values) and the corresponding average rate of pulse tran..
A meter stick is found to balance at the 49.7-cm mark when placed on a fulcrum. When a 60.0-gram mass is attached at the 27.0-cm mark, the fulcrum must be moved to the 39.2-cm mark for balance.
A certain magnetic core has a core loss of 8.4 W, of which one-third is eddy current loss, when the magnetizing field is changed 60 times a second. determine the core loss if the magnetizing field is changed only 50 times a second.
using CodeWarrior write a program to clear Register A, add five to Register A 10 times, and place the result in RAM Location $2000. Use a RAM location for holding the counter
Consider the signal s = [ 1 4 6 7 -2 3] A. Determine the least-squares approximation s^ of based on v(1), v(2), and v(5). B. Compute the squared approximation error ||s^ - s||^2. C. Show that s^ = s when v(0), v(1), v(2), v(3), v(4), and v(5) are use..
A single-phase, 60-Hz power will be transmitted through the transmission line Each subconductor's radius is 10 cm. There are two configurations, the first one is setting subconductors A and B as a bundle, and C and D as another bundle
Each phase of the load consists of an impedance of 30 + j40 ohms. Find the line to neutral voltage phasors, the line to line voltage phasors , the power and the reactive power delivered to the load. Assume that the phase of Van is zero.
Explain briefly from what you notice about the digital output values in (a) why a digital output value of an A/D converter is rarely the exact same digital value as the analogue input value.
Implement a multiple mode counter
Design an amplifier capable of providing the specified gain over a frequency range of 20 Hz to 10Khz under the following conditions. Input source is 2700ohms resistive, and the output load impedance is 32ohms resistive.
Design a state graph and state table for a Moore sequential circuit that has two inputs (X1 and X2) and one output (Z). The output begins at 0 and becomes 1 when X1 = 1 and X2 = 1, either concurrently or one after the other
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd