Some light rays from a small object sitting on the optical

Assignment Help Physics
Reference no: EM13631716

Some light rays from a small object sitting on the optical axis of a lens pass through a lens and then all of the rays emerging from the lens travel parallel to the optical axis. What can be said about the lens and the location of the object?

a. it is a diverging lens with the object located outside the focal point

b. it is a diverging lens with the object located insde the focal point

c. it is a converging lens with the object located at the focal point

d. it is a converging lens with the object located outside the focal point

e. it is a converging lens with the object located inside the focal point

Reference no: EM13631716

Questions Cloud

Find the electric field at the remaining upper right : three charges are at seperate corners of a square of edge length of 5cm. the two charges at opposite corners are
Air enters a compressor operating at steady state with a : air enters a compressor operating at steady state with a volumetric flow rate of 8 m3min at 23degc and 0.12 mpa. the
The time to failure of a battery in hours of a personal : the time to failure of a battery in hours of a personal handheld music device follows an exponential distribution. the
The probability of a manufacturing defect in an aluminum : the probability of a manufacturing defect in an aluminum beverage can is .00009. if 100700 cans are produced find the
Some light rays from a small object sitting on the optical : some light rays from a small object sitting on the optical axis of a lens pass through a lens and then all of the rays
Suppose thw weekly amount spent on repairs at a certain : suppose thw weekly amount spent on repairs at a certain computer is normally distributed with a mean of 300 and a
Also what wind speed can tip off this pole if we consider : a pole is 10ft tall and has a square base of 28inch by 28 inch. how much force is required to tip off this pole if the
To read the text you hold a magnifying glass with focal : 1. a thin lens with focal length f 50 cm is used to make an inmage of an object that is located a distance p 10cm
Determine the final pressure temperature and specific : two well-insulated and rigid vessels are interconnected by a pipe and a valve. one 85 liter vessel contains oxygen at

Reviews

Write a Review

Physics Questions & Answers

  Calculate the power which the engine must deliver to

a car with a mass of 1104 kg is coasting in neutral on a straightlevel road. it slows down and its speed as a function

  A vertical cylinder of cross-sectional area 006 m2 is

a vertical cylinder of cross-sectional area 0.06 m2 is fitted with a tight-fitting friction- less piston of mass 5.4

  How much work does the friction force do on the car

An 840 kg car needs to round a level curve with a radius of 23m.The driver wants to proceed at 56 kph. How much work does the friction force do on the car

  How hard and what direction must you pull on the third rope

One of your friends pulls on a rope with 3 units of force and other pulls on a second rope with 5 units of force, How hard and what direction must you pull

  Floor of a rotating cylindrical room falls away

At amusement parks, there is a popular ride where the floor of a rotating cylindrical room falls away, leaving the backs of the riders "plastered" against the wall. Suppose the radius of the room is 3.08 m and the speed of the wall is 10.6 m/s whe..

  A ray of light moving along the vector -i-2j undergoes

a ray of light moving along the vector -i-2j undergoes refraction at an interface of two media which is the x-z

  Illustrate what was the angular acceleration of the grinding

Illustrate what was the angular acceleration of the grinding wheel as it slowed down? Through what total angle did the wheel turn between t = 0 and the time it stopped?

  Estimate the pressure drop the hose to the other

A straight horizontal garden hose 37.0 m long with an interior diameter of 2.10 cm is used to deliver 20oC water at the rate of 0.430 liters/s.

  Elucidate where will the end of the spring line up

The end of the spring is next to the 13 cm mark on the ruler. If a 2.0-kg mass is now attached to the end of the spring, elucidate where will the end of the spring line up with the ruler marks?

  Assume the free electro model

a strip of Ag of thickness 0.01 cm has magnetic induction of 1.5 T applied perpendicular to the surface. a current of 1.2 A is passed along the strip. calculate the Hall voltage estalished (assume the free electro model; FCC with lattice parameter 4...

  What is the magnitude of the angular acceleration of pulley

A uniform, cylindrical pulley of mass M=12.7 kg and radius R=0.636 m rotates freely about a fixed horizontal axis. What is the magnitude of the angular acceleration of the pulley

  Coefficient of kinetic friction between block and surface

A bullet of mass 7.00g is fired horizontally into a wooden block of mass 1.29kg resting on a horizontal surface. The coefficient of kinetic friction between block and surface is 0.250. The bullet remains embedded in the block, which is observed to..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd