Seven kilograms of air is contained in a constant

Assignment Help Mechanical Engineering
Reference no: EM13712349

1) Four kilograms of water initially at 200 degree Celsius and 0.5 MPa undergo an isothermal, internally reversible compression process to the saturated liquid state.

Determine the work and heat transfer involved in the process (in kJ). Sketch the process on P?v and T?s coordinates. Associate the work and heat transfer with the areas on these diagrams.

2) Seven kilograms of air is contained in a constant? Volume tank with 327 degree in Celsius and 120 kPa. Then it is cooled to ambient temperature (27 Celsius).

Determine the entropy change of the air and universe due to the process and sketch the process on the T?s diagram.

3) Two kilograms of water execute a Carnot power cycle. During the isothermal expansion, the water is heated until it is a saturated vapor from an initial state where the pressure is 40 bar and the quality is 15%. The vapor then expands adiabatically to a pressure of 1.5 bar while doing 491.5 kJ/Kg of work.

(a) Sketch the cycle on P?V coordinates.

(b) Evaluate the heat and work for each process, in kJ.

 

(c) Evaluate the thermal efficiency.

Reference no: EM13712349

Questions Cloud

Calculate of power for adiabatic-two isothermal processes : Calculate of power [delivered heat/time] for adiabatic and two isothermal processes? Calculate of power [delivered heat/time] for this cycle which consists of two isobaric (constant pressure) and two isochoric (constant volume) processes?
K and l are mobile across sectors. : The next three questions pertain to the two-good (M,F)-two-factor (K-L) Harberger model.Unless noted otherwise, assume that each factor of production is always fully employed, allmarkets are competitive, and K and L are mobile across sectors.
What are the enthalpy and entropy changes of the steam : The state of 1 lbm of steam is changed from saturated vapor at 20 psia to superheated vapor at 50 psia and 1000 F. What are the enthalpy and entropy changes of the steam? What would the enthalpy and entropy changes be if steam were an ideal gas?
What is the exit temperature of cold water : An adiabatic heat exchanger is used to heat cold water at 8°C entering at a rate of 3 kg/s by hot air at 150°C entering also at rate of 3 kg/s. If the exit temperature of hot air is 30°C, what is the exit temperature of cold water? Use constant speci..
Seven kilograms of air is contained in a constant : Four kilograms of water initially at 200 degree Celsius and 0.5 MPa undergo an isothermal, internally reversible compression process to the saturated liquid state. Determine the work and heat transfer involved in the process (in kJ). Sketch the proce..
Distinguish between simple object access : Distinguish between Simple Object Access Protocol (SOAP), Web Services Description Language (WSDL), and Universal Description, Discovery, and Integration (UDDI).
Propeller thrust and power : Calculate the total net thrust generated by the propeller. Calculate the propeller power used to generate thrust. The turbine driving the propeller generates 416 kW of power. Calculate the efficiency of the propeller.
Companion viruses are an increasing problem : Hackers and their companion viruses are an increasing problem, especially on the Internet. What are the most important measures for a firm to take to protect itself from this? Is full protection feasible? Why or why not?
Active role in union-management negotiations : Active role in union-management negotiations - Do you think that it is appropriate for a government entity

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  If the undamped natural frequency is 10 khz and the damping

a pressure transducer behaves as a second-order system. if the undamped natural frequency is 10 khz and the damping is

  The minimum enclosed volume is 14 of the maximum enclosed

a six-cylinder four-stroke spark-ignition engine operating on the ideal otto cycle takes in air at 100 kpa and 25oc and

  Calculate the cycle thermal efficiency and the net work per

consider an ideal steam combined reheat and regenerative cycle in which steam enters the high-pressure turbine at 500

  The velocity at the nozzle exit

Air at 22 kPa, 220K and 250 m/s enters a turbojet engine in flight at an altitude of 10,000m. The diffusor slows the air down to a very low speed relative to its inlet. The pressure ratio across the compressor is 12. The turbine inlet temperature is ..

  Each rail is 33 ft long at what temperature will the rails

the steel rails of a railroad track are laid in the winter at a temperature of 15 f with gaps of 0.01 ft between the

  Determine the heat transfer and work transfer

Ten pounds-mass of R-22 is at an initial volume of 4.059 ft3 and pressure of 200 psia. It is compressed isobarically until its volume is two-thirds of its initial volume. The piston is then held in place as the refrigerant cools until its temperature..

  Descriptive questions - give brief answers in words no

descriptive questions - give brief answers in words. no calculations are required. you may write your answers in point

  The area of a rectangle with a perimeter of 200 cm is

the area of a rectangle with a perimeter of 200 cm is modeled by a function a 100l - l2 where l is the length of the

  Determine the r134a mass flow rate needed for this cycle to

an engineer has proposed that a simple ideal rankine cycle that uses refrigerant 134a be used to produce work with heat

  Both the siphon and the orifice diameters are 2in ignoring

a siphon pumps water from a large reservoir to a lower tank that is initially empty. the empty tank also has a rounded

  What is the speed when the object has moved 25 m if

a 20 kg object is pulled across a flat surface with a force of 100 n. the force is applied at a 30deg angle to the

  During a reversible process where the volume of the

one pound-mass of air at 78 degrees f and 75 psia is contained in a piston-cylinder device. during a reversible process

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd