Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A pulse is used to measure the frequency response of a system. Since we expect the frequency response to extend to 20 kHz, we want to select a pulse whose magnitude spectrum is constant within 1% out to 20 kHz.
A 5mm-long 100W microstrip line with velocity factor of 0.4 is used to fabricate a resonator at 3GHz. It is connected to an inductor at one end. Determine whether the other end of the microstrip line should be short circuited
Determine the relationship between the steady-state error to a ramp input and the gain K and system parameter b. For what values of K and b can we guarantee that the magnitude of the steady-state error to a ramp input
A buffer amplifier with a gain of 1 V/V has an input resistance of 1M and an output resistance of 10 ohm. It is connected between a 1-V, 100-k ohm source and a 100-ohm load. What load voltage results and what are the corresponding voltage, current,..
An LED is rated at VF = 1.6 Volts to 2.0 Volts at IF = 20 mA. What value of series resistance is needed to limit the LED current to 20 mA when this LED is connected to a 32 Volts peak source
Determine the location of the peaks in the following sampled spectrum for the following sine waves: (a.) signal frequency = 300 Hz; sampling frequency = 1 kHz (b.) signal frequency = 600 Hz ; sampling frequency = 1 kHz
A company has 100 metal halides (400W each with 1.2 ballast factor) and four motors (each with 50 hp capacity, 95% efficiency, 100% load factor, and 80% power factor). The power factor for the combined load
1) A 1.5H inductor has a constant current of 2.5A. a) find the energy that it holds b) what is its voltage c) what is its energy after its current drops to zero and stays zero What power is dissipated when a 20 olhm resistor is connected to it
A Si (ni = 1 e+10 cm^-3, eps = 11.7) p-n junction is doped with NA = 5.2 e+18 cm^-3 and ND = 8.4 e+14 cm^-3. What reverse bias (the absolute value) should be applied to the junction, in order to achieve the maximum electric field of 3.89E+4 V/cm
Assuming that directions of arrival are uniformly distributed at the mobile, how large is the correlation coefficient for a GSM 900 system between the channel in the middle and the end of the burst when the mobile station moves at 200 km/h
A pn junction may be formed by depositing a single crystal film of uniformly doped p-silicon onto a substrate that has been doped n-type. The substrate is 500um thick, and the film is 20um thick. The substrate has a 5 ohm-cm resistivity.
A DC circuit consists of a battery and a coil (not a resistor). The coil has a resistance of R = 5W and an inductance of L = 100mH. At a particular instant in time after a battery is connected across the coil, the current is i = 2.0 A
A series-connected circuit has a 240-V voltage source, a 10- resistance, a 5- resistance, and an unknown resistance Rx. The voltage across the 5-? resistance is 30 V. Determine the value of the unknown resistance.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd