Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Figure shows a system consisting of a three-phase wound-rotor induction machine whose shaft is rigidly coupled to the shaft of a three-phase synchronous motor. The terminals of the three-phase rotor winding of the induction machine are brought out to slip rings as shown. With the system supplied from a three-phase, 60-Hz source, the induction machine is driven by the synchronous motor at the proper speed and in the proper direction of rotation so that three-phase, 120-Hz voltages appear at the slip rings. The induction motor has four-pole stator winding.
a. How many poles are on the rotor winding of the induction motor?
b. If the stator field in the induction machine rotates in a clockwise direction, what is the rotation direction of its rotor?
c. What is the rotor speed in r/min?
d. How many poles are there on the synchronous motor?
e. It is proposed that this system can produce dc voltage by reversing two of the phase leads to the induction motor stator. Is this proposal valid?
What is the energy in joules stored in the capacitor below, The capacitor is shown with 10 volts on each side of it (plus on the left of the capacitor, - on the right), and C = 20 microfarads.
A p-n junction is made by doping Silicon with donors and acceptors. The doping at the p side has a uniform density of NA, but the doping density at the n side is not uniform and changes linearly with the distance from the metallurigical junction.
A belt is wrapped around a pulley creating a torque of 186 N-m. What power is being transmitted if the pulley is rotating at 200rpm
Analysing an RF splitter and power levels, A splitter is a device that has a single input and several outputs. It is used to send a signal to several different locations
The donor ground states for tellurium in GaAs are 5.9 meV below conduction band (there are 2 of them because of spin). Atroom temperature (300 K), what is probability that a given ground state is occupied if the Fermi level (Ef) is 0.1 eV below Ec
If someone presses the 1 or First floor button, the elevator should go to the 1st floor, open the door and remain in this state for a small amount of time, then close the door. Assume the elevator takes one clock cycle to travel.
1. Describe the advantages of an integrated design approach for the delivery of high performance buildings, including how they can potentially reduce the initial costs of a "green" project.
A solenoid consists of 400 turns per meter and carries a currentof .45 Amperes. A 20 turn coil is wrapped tightly around thecircumference of the solenoid. The ends of the solenoid areconnected to a 2 Ohm resistor.
Given a geostationary satellite with 36,000 km altitude, a downlink frequency of 4 GHz and a ground receiver with a 1/3 m diameter dish.What is the satellite transmitter's EIRP in order for a 1 pW input to the ground receiver
a certain shunt motor armature has a resistance of 0.07 and a current of 50 amperes at 120 volts. determine the counter emf
Consider an Internet video conferencing application. Assume that the compressed video streams are packetized, and that a packet is either lost (due to over long delay or mis-delivery or detected bit errors within a packet) or received intact.
What happens to the program counter (PC) when a subroutine is called. What register is used to keep track of the return point. What happens to the register that keeps track of the return point if a subroutine calls another subroutine
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd