Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The residual stresses adjacent to a long butt weld between two deck plates of a ship were found by x-rays. The average values of the lattice parameter, a, were a = 2.8619 parallel to the weld bead and a = 2.86106 perpendicular to the weld bead. For unstrained material, a = 2.8610. Find the values of the residual stresses parallel and perpendicular to the weld. Assume E = 30 × 106 psi, υ = 0.29, and that the stress normal to the plate is zero.
A 4 cylinder 1.6 liter SI engine has a compression ratio of 10, connecting rod length of 16.8cm, and a crank offset of 4.5 cm. The engine is operating at 3000 RPM and wide open throttle. The exhaust pressure is 100 kPa. The intake valve closes at 20 ..
the 12-mg truck drives onto the 350-mg barge from the dock at 20 kmh and brakes to a stop on the deck. the barge is
a parachutist of mass 70 kg jumps from a plane at an altitude of 32 km above the surface of the earth. unfortunately
A wind turbine has a rotor diameter of 60 m. The wind speed is 10 m/s. The power coefficient of the rotor is 0.48 and the efficiency of the drive train is 0.9. The air temperature is 15°C, the air pressure is 101 kPa and the density of the air is 1.2..
the true stress-strain curve of a material obeys the power-hardening law with n 0.18. a piece of this material was
1-listening is often the most important aspect of good communication. why is this factor often ignored? what can
a vessel contains 2 litres of gas at a pressure of 300kpa and a temperature of 27c .3 litres of gas at the same
Air enters a well-insulated turbine operating at steady-state conditions with negligible inlet velocity, 4 MPa, and 100°C. The air expands to an exit pressure of 100 kPa. The exit velocity and temperature are 90 m/s and 100°C, respectively. The diame..
a 12-ft3 rigid tank contains refrigerant-134a at 40 psia and 55 percent quality. heat is transferred now to the
A hot-water cylinder contains 150 liters of water. It is insulated, and its outer surface has an area of 3.5 m^2. It is located in an area where the ambient air is 250C, and the overall heat transfer coefficient between the water and the surroundings..
A 1.5in diameter rod 20ft long elongates .48in under a load of 53 kips. the diameter of the rod increases .001in during loading. Determine the poisons ratio, modulus of elasticity, and shear modulus
refrigerant-134a is gaining heat at a rate of 4 kws as it passes trough the diffuser. it enters the diffuser as
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd