Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
(a) Try to represent the amplitude spectrum and the phase spectrum of a sawtooth one directly beneath the other as in Exercise 1. Select amplitude spectrum on channel 0 in the menu of the module "frequency domain" and "phase spectrum" on channel 1. Select "standard setting" (sampling rate and block length = 1024 = 210 in the A/D button of the upper control bar) and a low frequency (f = 1; 2; 4; 8 Hz. What do you discover if you choose a frequency whose value cannot be given as a power of two?
(b) Select the different phase modifications π (1800), π/2 (900), π/3 (600) and π/4 (450) for the sawtooth in the menu of the generator module and observe the changes in the phase spectrum in each case.
(c) Do the phase spectra from Exercise 2 agree with the 3D representation in Illustration 28 ff.? Note deviations and try to find an explanation for the possible erroneous calculation of the phase spectrum.
(d) Experiment with various settings for the sample rate and block length (A/D button on the upper control bar, but select both values in the same size, e.g. 32, 256, 1024!)
This is a group project which will require working with another student. The project is a design project using Multisim with the requirements given below. The project is due on the last day of the term.
What are some of the possible biases and points of error that may arise in team communication systems and what are the advantages and disadvantages of a transactive memory system (TMS) in a team
Assume for now that all components are powered up simultaneously and that event detection is instantaneous. This means that one does not need to consider sampling or processing time. Also, all three sensors are required for unambiguous event detec..
In doing so, they learned through laboratory studies that the maximum growth rate of the bacteria will be 0.66 day -1 and that the half-saturation constant will be 64.5 mg L-1.
Write a function called Balloon that will accept a single variable named S. The function should replace S with the square of S and repeat this process until S is either greater than 10^15 or less than 10^-15.
What will be the total impedance of a series circuit having a resistor of 100 ohms, an inductor of 200 ohms reactance, and a capacitor of 300 ohms reactance. Also, what will be the dissipated power when voltage source is 10sin1000t.
Discuss how the angle of the incident light affected the solar cell? How could solar cell designs and/or installations be designed to counter this affect?
In a bridge rectifier the transformer is connected to 220V, 60Hz mains and the turns ratio of the step down transformer is 11:1. Assuming the diode to be ideal, find: i) Idc
Use a 5nF capacitor to design a series RLC bandpass filter in series. the center frequency of the filter is 8kHz, and the quality factor is 2. perform the analysis in Pspice and graph the transfer function on the y axis vs.
Use Source Transformation to find V1 and V2?
The 741 op amp is usually modeled on specification sheets as a voltage amplifier having the following parameters: Rin = 1 M, Av = 100,000, and Rout = 100 Using this information, develop equivalent circuits for the 741 as a current amplifier
Two nickel-cadmium batteries provide electrical power to operate a satellite transceiver. If both batteries are operating in parallel, they have an individual failure rate of 0.1 per year.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd