User Account

All Pages

Prove that the average cost of correcting a page

Assignment Help Physics
Reference no: EM13887287

The number of errors needing correction on each page of a set of proofs follows a Poisson distribution of mean μ . The cost of the first correction on any page is α and that of each subsequent correction on the same page is β . Prove that the average cost of correcting a page is
α + β ( μ - 1) - ( α - β ) e - μ .

Reference no: EM13887287

Questions Cloud

Predict ratio of average graphite ?ake : Class 20 and class 60 gray cast irons have tensile strengths of about 20 and 60 ksi respectively. Assuming that the fractures start from graphite ?akes and that the ?akes act as preexisting cracks, use the concepts of Grif?th analysis to predict t..
Discuss response actions required in the event of a spill : Discuss response actions required in the event of a spill or release
Why is internal control important to an organization : Why is internal control important to an organization? How does internal control help an organization achieve reliable financial reporting?
Devise a strategy to compete in this environment : Much of the intense competition in the financial services industry comes from products that are the most standardized, such as mortgages, automobile loans, money market accounts, savings accounts, and so on. These products will offer very low profit ..
Prove that the average cost of correcting a page : The number of errors needing correction on each page of a set of proofs follows a Poisson distribution of mean μ . The cost of the first correction on any page is α and that of each subsequent correction on the same page is β .
Theoretical predictions of fracture strength : Using the two theoretical predictions of fracture strength, (A) σt = E/π (Equation ( 14.4)) and (B) σt = √(γE/ao) (Equation (14.8)), calculate the theoretical fracture strength of (a) iron and (b) MgO.
Would the action be considered an operational issue : Would the action be considered an operational issue and not a control deficiency, or would it likely constitute a material weakness or significant deficiency in internal control?
What are the basic arguments for increasing capital : What are the basic arguments for increasing capital requirements at large commercial banks? In what ways will depositors, stockholders, and society in general benefit? How might each group be disadvantaged? As commercial banks enter new lines of busi..
Value of specifying charpy : Is it safe to say that brittle fracture can be avoided in steel structures if the steel is chosen so that its Charpy V-notch transition temperature is below the service temperature? If not, what is the value of specifying Charpy V-notch test data ..

Reviews

Write a Review

Physics Questions & Answers

  What is the maximum compression of given spring

Two blocks slide on a horizontal, frictionless surface with two springs on opposite sides. Block A has mass 1.14 kg and Block B has mass 3.27 kg. What is the maximum compression of Spring 2

  A screen is placed490cm from a single slit which is

question a screen is placed49.0cm from a single slit which is illuminated with light of wavelength 677nm. if the

  Find the original speed of the bullet

A 7 g bullet collides horizonally with a 43 g block resting on a frictionless horizontal surface as shown in the accompany diagram. The bullet remain embedded in the block and subsequently causes the block to slide down a frictionless slope onto a..

  Calculate the duration of the impact

A 0.500 kg hammer is moving horizontally at 6.50 m/s when it strikes a nail and comes to rest after driving it 1.00 cm into a board. Calculate the duration of the impact

  Determine the final volume of the gas in the given cylinder

Two cylinders each contain 0.30 mol of a diatomic gas at 270 K and a pressure of 3.0 atm. What is the final volume of the gas in the cylinder B

  Find where is the center of mass of the three bricks

Two bricks are adjacent, and a third brick is positioned symetrically above them. Where is the center of mass of the three bricks

  Child swings on rope with length of metershanging from tree

A 34.3 kg child swings on a rope with a length of 6.28 metershanging from a tree. At the bottom of the swing, the child is moving at a speed of 4.2 m/s. What is the tension in the rope?

  How long is the rocket in the air

Suppose the second distance d were traveled in the opposite direction; you forgot something and had to return home at the same constant speed as found in part (a). What is the average velocity for this trip.

  What is the velocity of the wood block

A 0.07 kg bullet traveling at 599 m/s hits a 6.7 kg block of wood, What is the velocity (speed)of the wood block immediately after the bullet hits it

  Find the ratio of their speeds

An electron starting from rest get 6.3keV of KE in moving from point C to point D. Find the ratio of their speeds at the end of their respective trajectories

  Obtain the final charge on each object

Four identical metallic objects carry the following charges: +1.18, +6.89, -4.92, and -9.56C. The objects are brought simultaneously into contact, What is the final charge on each object

  Evaluate what is the magnitude of the braking force

A 65kg bicyclist rides his 9.8kg bicycle with a speed of 13m/s. What is the magnitude of the braking force

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd