Power generated by the turbing exactly equals this power

Assignment Help Mechanical Engineering
Reference no: EM13626026

Given conditions to a jet engine problem. (steady flow)

Rate of work = 2e7 J/s

Power generated by the turbing exactly equals this power required by the compressor.

Air enters at T=300K, P =0.1MPa, V=50m/s, mass flow rate = 40kg/s

Air leaved at P=0.12MPa, V=350m/s

Heat Transfer rate in combustion process is = 5e7J/s

a.) Find the enthalpy per unit mass at the exit of the engine.

b.) Find the temperature at the exit of the engine.

c.) Find the cross sectional aread of the engine intake.

Reference no: EM13626026

Questions Cloud

The electrical potential of the ground was measured at the : q1. the electrical potential of the ground was measured at the top off a hill. if the height of the hill is 20 meters
Is there a statistically significant correlation between : according to the university of chicago as men age their cholesterol level goes up. a new drug xab is being tested to
Calculate the mass of vapor at the beginning and end of the : a closed and rigid tank with 1.5 m3 volume initially contains saturated vapor refrigerant 134a at 50deg c. the system
Transverse waves with a speed of 520 ms are to be produced : transverse waves with a speed of 52.0 ms are to be produced on a stretched string. a 5.40-m length of string with a
Power generated by the turbing exactly equals this power : given conditions to a jet engine problem. steady flowrate of work 2e7 jspower generated by the turbing exactly equals
What is the value of the test statistic answer is t 204 but : two researchers wiebe and bortolotti in 2002 examined the color in tail feathers of northern flickers. it sometimes
Consider a regenerative rankine cycle with a 600c and 4-mpa : consider a regenerative rankine cycle with a 600c and 4-mpa throttle a 5-kpa condenser and an open feedwater heater at
Determine the distance along the floor from the point of : a tennis ball is initially at a height of 4 m above a solid marble floor. the tennis ball is traveling 15 msec at an
Using a 05 test to see if there is a significant : ten observations were selected from each of 3 populations and an analysis of variance was performed on the data. the

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Which is probably mechanically tougher the bone or the

toughness is proportional to the amount of energy storedput in to a material or structure when a stress is applied.

  Why does a car engine stop when we turn the key even when

why does a car engine stop when we turn the key even when the vehicle is running? the engine should run on alternator

  Find the pressure with which the water is fed into the

a fountain produces a vertical jet of water which rises to a height of 30 m before falling back into a pond. if the jet

  Determine the power required to maintain the clean rooms

at steady state a refrigeration cycle maintains a clean room at 55of by removing energy entering the room by heat

  Estimate the largest possible force in n that can be

a circular bar of radiusr 1 cm is placed horizontally between two vertical supports that are separated by distancel

  Calculate the thermal efficiency of this cycle

The Brayton cycle shown in figure 6.41 operates using CO2 as a working fluid with compressor and turbine isentropic efficiencies of 1.0. Calculate the thermal efficiency of this cycle when the working fluid is modeled.

  Consider a 20-l evacuated rigid bottle that is surrounded

consider a 20-l evacuated rigid bottle that is surrounded by the atmosphere at 100 kpa and 27 celsius. a valve at the

  If the body has a forward speed of 2 insec and its position

a retarding force is applied to a body moving in a straight line so that during an interval of its motion its speed u

  Determine the magnitude of the acceleration at the instant

to analyze the motion of a body that is traveling along a curved path to determine the bodys acceleration velocity and

  Please use ees to solve this problemone method for storing

please use ees to solve this problem.one method for storing hydrogen involves cooling it so that it liquefies. figure

  Its free response amplitude decays such that the amplitude

a mass-spring-damper system has a mass of 100 kg. its free response amplitude decays such that the amplitude of the

  The mean diameter of a conical friction clutch

The mean diameter of a conical friction clutch is 250mm with a width of the conical surface being 50mm. The clutch is lined with a material having a coefficient of friction of 0.25

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd