Plot the cost versus r for 2 le r le 10 m and determine the

Assignment Help Mechanical Engineering
Reference no: EM13637597

A water tank consists of a cylindrical part of radius r and height h, and a hemispherical top. The tank is to be constructed to hold 500 m3 of fluid when filled. The surface area of the cylindrical part is 2πrh, and its volume is πr2h. The surface area of the hemispherical top is given by 2πr2, and its volume is given by 2πr3/3. The cost to construct the cylindrical part of the tank is $300/m2 of surface area; the hemispherical part costs $400/m2. Plot the cost versus r for 2 ≤ r ≤ 10 m, and determine the radius that results in the least cost. Compute the corresponding height h.

Reference no: EM13637597

Questions Cloud

I the electroysis of an aqueous solution agno3nbsp067gof : in the electroysis of an aqueous solution agno3nbsp0.67gof agis deposited after a certain period of time. what is the
Pseudoepedrine to metamphetamine the entire mechanism with : pseudoepedrine to metamphetamine? the entire mechanism withthe substitutions and movement of electrons with explanation
A football is kicked straight up into the air it hits the : a football is kicked straight up into the air it hits the ground 5.4s later.what was the greatest height reached by the
If the initial pressure of nh3gnbspis 7845 atmcalculate the : if the initial pressure of nh3gnbspis 7.845 atmcalculate the of nh3gnbspleft over after the reaction reaches
Plot the cost versus r for 2 le r le 10 m and determine the : a water tank consists of a cylindrical part of radius r and height h and a hemispherical top. the tank is to be
Estimate the steady-state heat loss from the pipe in wm : a 25-cm diameter oil line is buried with its centerline 60 cm below the ground. assuming a soil temperature of 10
What is the coulomb force on the charge at the origin due : consider the following 3 charges a -2 microcoulomb charge located at the origin a 2 microcoulomb charge located on the
How many kilogram of methane gas must be discharged in a : how many kilogram of methane gas must bedischarged in a room of 306 cubic meters to reach the lower explosive limit of
Suppose a van de graaff generator builds a negative static : suppose a van de graaff generator builds a negative static charge and a grounded conductor is placed near enough to it

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The cutting force fc is found to be 1780n 400lb and the

in a turning operation the feed rate t is .13 mm .005 in. and the depth of cut normal to the plane of the paper is

  Find the cartesian components of tension tda which is

learning goal to determine cartesian force components from magnitude and determine position and resultant vectors by

  The acceleration of a particle is given by a -ks2 where a

the acceleration of a particle is given by a -ks2 where a is in meters per second squared k is a constant and s is in

  A supply of steam at 100 kpa 150degc is needed in a

a supply of steam at 100 kpa 150degc is needed in a hospital for cleaning purposes at a rate of 15 kgs. a supply of

  If the internal pressure equals that of the free stream

a high rise office building located in a city at sea level is exposed to a wind of 75 kmh. what is the static pressure

  Calculate the cross sectional area in mm2 calculate the

the diameter of a round wire is d in mm. put d 3.00 mm using d 3.00mm and calculate the following calculate the cross

  You are considering replacing the diesel engine for problem

you are considering replacing the diesel engine for problem 4 with a microturbine with a pressure ratio of 8. the

  The masses of the bar and the disk are 5 kg and 10 kg

the masses of the bar and the disk are 5 kg and 10 kg respectively. the coefficient of kinetic frictionnbspbetween the

  The outer diameter of this tube is 60 mm determine a the

a tube with elastic modulus of 75 gpa is used to support a compressive load. it is required that this tube must not

  If the refrigerator is reconfigured to work as a heat pump

a refrigerator operates with a coefficient of performance of 4.2 and requires an electrical input of 700 w. if the

  Determine the final absolute pressure kpa of the gas

the pressure of a gas inside a piston-cylinder device is initially balanced by an atmospheric pressure of 100kpa and an

  The collar at a can freely slide in the y-direction and can

a vertical bar ed has a circular cross-section and is fixed at e. member abc is a single member that lies on the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd