### Part 1 a piston-cylinder assembly has the piston fixed in

Assignment Help Mechanical Engineering
##### Reference no: EM13639231

Part 1: A piston-cylinder assembly has the piston fixed in place so it cannot move. The internal chamber is divided into two equal parts by a temporary partition. Initially there is 50 kg of water at 200 kPa and 25 C on one side of the partition. The other side is initially evacuated. Then the partition is quickly removed and the water expands to fill the entire chamber. The piston is still in a fixed position. The water is allowed to exchange heat with the surroundings until state 2 is reached when the temperature in the tank returns to the initial value of 25 C.

Determine:

a) The volume of the system; v=0.100m^3

b) The final pressure of the water; p= 3.169kPa

c) The final specific volume of the water; v=0.002 m^3/kg

d) The heat transfer for this process; Q=2.65kJ

e) How much energy must be transferred for this process from State 2 to State 3?

### Write a Review

#### If heat transfer from the heat exchanger to its

steam enters a heat exchanger operating at steady state at 250 kpa and a quality of 90 and exits as saturated liquid at

#### Determine diameter of a circular rod of ductile material

determine diameter of a circular rod of ductile material with a fatigue strength ,e=280 Mpa. Add a tensile yield strength of 350 Mpa. The member is subjected to a varying axial load from 700 kN to -300kN. Assume Kt=1.8 and factor of safety=2.

#### A highway patrol officer on the ground uses a radar gun to

1 a highway patrol officer on the ground uses a radar gun to measure the speed of a suspects car to be 60 ms. a patrol

#### Determine the rate of heat loss at the compressor exit

refrigerant 134-a enters a compressor as a saturated vapor at 200 kpa at a rate of 0.04 m3s. the power input to the

#### Determine the largest allowable bending moment bending

reinforced concrete highway pavement has a depth of 250 mm with 24 mm diameter steel rebars located 180 mm from the

#### Draw schematics of a heat engine and b refrigeration

draw schematics of a heat engine and b refrigeration devices. label the reservoirs the type of energy transfer and the

#### Assuming the water heater acts as a heat sink having an

cold water at 10degc enters a water heater at the rate of 0.02 m3min and leaves the water heater at 50degc. the water

#### The combustion gases modeled as air enter a turbine at

the combustion gases modeled as air enter a turbine at 6atm 1000k and exits at 1atm 500k. determine the isentropic

#### Tests reveal that a normal driver takes about 075 seconds

tests reveal that a normal driver takes about 0.75 seconds before he or she can react to a situation to avoid a

#### Dring the displacement a constant force f 4 n i - 4 n j

a 5-kg object is given a displacement r -4 m i 1 m j - 3 m k along a straight line. during the displacement a

#### Calculate the mass concentration in microgm3 of a

calculate the mass concentration in microgm3 of a mono-dispersed aerosol with dp 10.0 micron rhop 2.1 g cm-3 and n

#### Calculate the internally reversible efficiency using the

for various fuels including at least methane ch4 octane c8h18 kerosene c12h26 methanol ch3oh ethanol c2h5oh and