Over a flat portion of the salt lake bed in utah the wind

Assignment Help Mechanical Engineering
Reference no: EM13630248

Over a flat portion of the salt lake bed in Utah, the wind can blow at a relatively steady velocity of 9.6 m/s. The flat portion has a length of 118 m, and the air temperature is 20 °C. During the summer the lake bed can reach a temperature of 60 °C. Ignoring natural convection, compute the average heat flux over the flat portion of the lake bed. What would be the energy flux (J/m2) if the conditions are held steady over a 3.8-hour period? Table of thermal properties of air at 1 atm.

Reference no: EM13630248

Questions Cloud

Oil with a specific gravity of 070 is used as the : oil with a specific gravity of 0.70 is used as the indicating fluid in a manometer. if the differential pressure across
Cylindrical conductor with radius r and length l carries a : cylindrical conductor with radius r and length l carries a uniformly distributed net charge q. this conductor is
A 0107-kg ball is dropped from a height of 103 m and lands : a 0.107-kg ball is dropped from a height of 1.03 m and lands on a light approximately massless cup mounted on top of a
1 find the solid angle subtended by a f1 lens at a point : 1 find the solid angle subtended by a f1 lens at a point source located at its focus.2 find the radian intensity of a
Over a flat portion of the salt lake bed in utah the wind : over a flat portion of the salt lake bed in utah the wind can blow at a relatively steady velocity of 9.6 ms. the flat
A 0107-kg ball is dropped from a height of 103 m and lands : a 0.107-kg ball is dropped from a height of 1.03 m and lands on a light approximately massless cup mounted on top of a
A 377-kg ball of clay is thrown downward from a height of : a 3.77-kg ball of clay is thrown downward from a height of 3.47 m with a speed of 4.81 ms onto a spring with k 1690
A 132 kg axial load is uniformly carried by an aluminum : a 13.2 kg axial load is uniformly carried by an aluminum pipe with an outside diameter of 10.0000 cm and an inside
A 255-kg model rocket is launched vertically upward with : a 2.55-kg model rocket is launched vertically upward with sufficient initial speed to reach a height of 2.83middot102 m

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The liquid water stream enters at 60 psia and 60f then

a mixing chamber combines superheated steam and liquid water to produce a stream of saturated steam with a quality of

  Determine the normal stress in the central portion of link

the link DE is 3mm thick and 25 mm width,determine the normal stress in the central portion of the link.

  The load at point bis not allowed to swing more than 4 m

the crane shown below consists of a 10 m swinging arm that is pinned at point a in the horizontal axis. the load at

  A 3-ft-diameter circular plate is located in the vertical

a 3-ft-diameter circular plate is located in the vertical side of an open tank containing gasoline. the resultant force

  Pressures change from 325 k and 125 kpa to 500 k and 300

during actual expansion and compression processes of gases pressure and volume are often related by pvn c where n and

  A flashlight is powered for 30 minutes by a 9-v battery

a flashlight is powered for 30 minutes by a 9-v battery supplying power at 0.5 amps.a find the resistance of the

  Explain what is the basic design load rating

Design life is 9630 hours, rotating at 250 rpm, load of 880 lbs, what is the basic design load rating (assuming no axial loads)?

  Single stroke positive displacement pump

Design and construction of a modified single stroke positive displacement pump

  A 3-phase 25 kva 208 v 60 hz alternator generator is

a 3-phase 25 kva 208 v 60 hz alternator generator is operating under balanced conditions and supplies a current of 20 a

  A 3084-kg steel projectile is fired from a gun at a

a 3.084-kg steel projectile is fired from a gun. at a particular point in its trajectory it has a velocity of 300 ms an

  Design a hydraulic circuit that will cause the 2 cylinders

design a hydraulic circuit that will cause the 2 cylinders to extend and retract using a single directional control

  A simply supported aluminum beam is found to deflect 04 in

a simply supported aluminum beam is found to deflect 0.4 in. at location a when a force of 2001b is applied at b. what

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd