Optimum length of the antenna to receive the fm station

Assignment Help Electrical Engineering
Reference no: EM13139264

Optimum length of the antenna to receive the FM station
An FM radio station transmits at a frequency of 99.9 MHz. A radio receiver has an antenna that is a quarter wavelength monopole consisting of a telescoping rod (as seen on most portable FM radio receivers). What is the optimum length of the antenna to receive the FM station, correct to the nearest cm?

Reference no: EM13139264

Questions Cloud

How is knowledge of dna and technology being used : How is knowledge of DNA and technology being used today to do things that we could not have done 50 years ago? How does control of gene expression affect biotechnology? What is your personal experience with DNA technology?
Calculate the gas density in g/l : An evacuated (empty) 276 mL glass bulb weighs 129.6375 g. Filled with an unknown gas, the bulb weighs 130.0318 g. Calculate the gas density in g/L.
Why did market react differently to these announcements : Two firms both announce 20 percent earnings increase. One firm’s stock increases substantially and the other firm’s stock is basically unchanged. Why did market react differently to these announcements?
Determine the order of the reaction : Consider the following reaction: A -> B + C. The initial reaction rates corresponding to the initial concentrations of 0.110 and 0.220 mol/L were 0.00817 mol/(L*s) and 8 times that amount. Determine the order of the reaction. Round your result to ..
Optimum length of the antenna to receive the fm station : Optimum length of the antenna to receive the FM station, An FM radio station transmits at a frequency of 99.9 MHz. A radio receiver has an antenna that is a quarter wavelength monopole consisting of a telescoping rod
Decompose ibm roe : In the seven years (since 1994), that Lou Gerstner has reigned over IBM, the company’s earnings per share have increased an average of 27% per year. Decompose IBM’s ROE and discuss the factors (and trends) that contribute to Big Blue’s profitabil..
What mass of ccl2f2 substance must evaporate : What mass of CCl2F2 substance must evaporate in order to freeze 135 g of water initially at 15 degrees celsius? (The heat of fusion of water is 334 J/g the specific heat of water is 4.18 J/gK .)
Reserve bank has lowered the cash : Since November 2011, the Reserve Bank has lowered the cash rate on eight separate occasions from 4.75% to 2.5%. Clearly, the Bank has become far less concerned about inflation and is giving a much greater emphasis to unemployment in its policy reacti..
Interest share of consolidated net income : Gallow's reported net income was $204,000, and Race's net income was $806,000. Race decided to use the equity method to account for this investment. What was the noncontrolling interest's share of consolidated net income?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define the transmission line has an impedance

The transmission line has an impedance of 600 ohms and is terminated in a load of 600 ohms. The transmitter delivers an average power of 0.1 W to the input of the line.

  Digital systems and microprocessors

Design a sequential system to continuously output your set of eight different digits (01275438) in binary at the rate of one digit per clock pulse.

  Presuming that ideal filters are available

Assuming that ideal filters are available, what is the lowest frequency at which the signal can be sampled and subsequently recovered in its analog form without distortion using a low pass filter?

  Define laplace transform of a pulse

Laplace transform of a pulse, Consider computing the Laplace transform of a pulse: use the integral formula to find P(s)

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Find out the voltage required on the input

Determine the voltage required on the input of the amplifier to give the maximum output of 85 dBuV. If the signal level from the aerial is 5 dBmV and the input noise level is 20 dBuV, calculate the signal-to-noise ratio on the output of the amplifi..

  Design a device that remotely control at least two actuators

The purpose of this project is to design a device that would remotely control (from a Bluetooth-enabled mobile phone for instance) at least two actuators (e.g. relays and switches).

  Write down the principle of energy conversion

Write down the principle of energy conversion and give an example for single and double excited system.

  Define the network is used for voice communications

The network is used for voice communications. Is it possible for one mobile unit to connect to another mobile unit directly? What advantage is there in connecting through the hub?

  Modulating radio frequency carriers for carry digital data

Modulating Radio Frequency Carriers to Carry Digital Data, Digital radio transmission requires the use of a carrier wave which is modulated by the digital data.

  Determine ideal impulse response using inverse discrete-time

Determine ideal impulse response using inverse discrete-time Fourier transform. An ideal low-pass filter is described in the frequency-domain by

  Problem on transmission line operation

Evaluate the TL parameters. Include the effect of the earth as ideal. Do not incorporate the effect of the shield wires.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd