N-butane c4h10 is burned with 80 percent theoretical air

Assignment Help Mechanical Engineering
Reference no: EM13624034

N-butane (C4H10) is burned with 80 percent theoretical air, and the products of combustion, an equilibrium mixture containing only O2, CO, CO2, H2, H2O, N2, NO, and NO2, exit from a combustion chamber at 2000 K, 0.2 MPa. Determine the equilibrium composition at this state. Assuming the reactants are premixed and enter the combustion chamber at 298 K, 0.2MPa, determine the heat transfer to or from the combustion chamber in kJ per kmol of nbutane. (Hint: the concentrations of O2, NO, and NO2 will be much lower than the other concentrations).

Reference no: EM13624034

Questions Cloud

If the solenoid in exercise 55 is free to turn about the : if the solenoid in exercise 5.5 is free to turn about the vertical direction and a uniform horizontal magnetic field of
Prove using the increse in entropy principle that the : a prove using the increse in entropy principle that the maximum thermal efficiency for any heat engine is the carnot
A car starts from rest with an acceleration of 1300 mih2 : a car starts from rest with an acceleration of 1300 mih2 which remains constant until its velocity reaches 65 mph.
After reaching the bottom of the slope the block continues : a 20.0-kg block slides down along a 30 degree incline from a height of 20.0ma if the block reaches the bottom of the
N-butane c4h10 is burned with 80 percent theoretical air : n-butane c4h10 is burned with 80 percent theoretical air and the products of combustion an equilibrium mixture
Find the force required to give a helicopter of mass m an : find the force required to give a helicopter of mass m an acceleration of 0.25g upward. what would be the apparent
Tomato juice having a concentration of 12 wt solids is : tomato juice having a concentration of 12 wt solids is being concentrated to 25 solids in a film-type evaporator. the
A motorist traveling along a straight portion of a highway : a motorist traveling along a straight portion of a highway is decreasing the speed of his automobile at a constant rate
Calculate the thrust in newtons that is needed for : the mars rover curiosity is on its way to the landing area on mars. it will descend by using several stages of slowing

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Use your equation to calculate the pressure in mb at 1200 m

assume that in a certain area the atmospheric lapse rate ?gamma subscript actual is equal to zero from the ground up to

  Analysis using ansys fea is required linear structural

analysis using ansys fea is required. linear structural vibrationmodal and steady state thermal analysis can be use to

  Calculate the magnitude of the moment

Calculate the magnitude of the moment about the base point O of the 600 N force and calculate and draw the shear force and bending moment diagram for the cantilever beam

  Steam at 10 mpa 600 degrees c enters the first-stage

steam at 10 mpa 600 degrees c enters the first-stage turbine of an ideal rankine cycle with reheat. the steam leaving

  Determine the maximum total bending moment

Determine maximum total bending moment (static plus dynamic) of the beam under steady-state conditions.

  The outer ring rotates and the bearing carries a combined

a 60 mm bore 02 series double row angular contact ball bearing has a 15 degrees contact angle. the outer ring rotates

  Compute the power required to overcome the skin

Calculate the power required to overcome the skin friction drag on the keel of a sailing dingy moving through water at 2m/s. The keel projects 0.8m into the water and it is 0.4m wide

  What will be the change in energy of a metalpart if it

fabricating metal parts by drilling holes in the metal can cause the parts to get quit hot. what will be the change in

  The ball at is kicked such that 60 if it strikes the

the ball at is kicked such that 60 . if it strikes the ground at having coordinates 25 -25 determine the speed at

  Water at 300 kpa with a quality of 50 has a temperature

water at 300 kpa with a quality of 50 has a temperature raised 20oc in a constant pressure process. what is the new

  Determine the reading on the pressure gage in psig when all

a transparent rigid container is filled with 2 gallons of water. initially the pressure is measured to be 10.2 psig

  Calculate the value of forces

Calculate the value of forces P and Q for each test using the method of sections technique.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd