Maximum shear stress developed in the shaft

Assignment Help Mechanical Engineering

Reference no: EM13702493

The 60-mm diameter shaft rotates at 300 rev/min. this motion is caused by the unequal belt tensions on the pully of 800 N and 450 N. Determine the power transmitted and the maximum shear stress developed in the shaft.

Reference no: EM13702493

Questions Cloud

First tubes and on the tubes deep in teh array : Air at 20C flows over a very large bank of 2 cm OD tubes that are kept at 100C. the air approaces at an angle of 15 degress off normal to the tubes. the tube array is staggered, with SL= 3.5 CM and ST= 2.8 cm. Find Average h on the first tubes and on..

Calculate the ratio of the turbulent h to the laminar : Water at 24 degree C flows at 0.8 m/s in a smooth, 1.5 cm I.D. tube that is kept at 27 degree C. The system is extremely clean and quiet, and the flow stays laminar until a noisy air compressor is turned on in the laboratory. Then it suddenly goes tu..

Two copper slabs problem : Two copper slabs, 3cm thick and insulated on the outside are suddenly clamped tightly together. The one on the left side is initially at 100 C and the one on the right side at 0c. Determine the left-hand adiabatic boundary's temperature after 2.3s ha..

Steam condenses-what is the mass rate of condensation : Steam condenses in a 2cm I.D. thin walled tube of 99% aluminium at 10atm pressure. There are circular fins of constant thickness, 3.5cm in diameter, and every 0.5 cm on the outside. The fins are 0.8mm thick and the heat transfer coefficient from them..

Maximum shear stress developed in the shaft : The 60-mm diameter shaft rotates at 300 rev/min. this motion is caused by the unequal belt tensions on the pully of 800 N and 450 N. Determine the power transmitted and the maximum shear stress developed in the shaft.

An ideal diesel cycle has a compression ratio : An ideal diesel cycle has a compression ratio of 16.8 and a cut off ratio of 1.63. Determine the maximum air temperature and the rate of heat addition to this cycle when it produces 197 hp of power, the cycle is repeated 1,250 times per minute, and t..

Water is the working fluid in regenerative rankine cycle : Water is the working fluid in a regenerative Rankine cycle. The pressure and temperature at the turbine inlet are 8MPa and 550?C, respectively, and the condenser pressure is 7.5KPa. The mass flow rate of steam entering the turbine is 176kg/s.

Determine the isentropic efficiency : Steam at 5.0 MPa, 500 degrees C enters an insulated turbine operating at a steady state with a mass flow rate of 7kg/s and exits at 0.3 MPa. Kinetic and Potential energy effects are negligible. Determine the maximum theoretical power that can be deve..

Pressures-temperatures and specific volumes around the cycle : A cycle composed of three processes: poly tropic compression (n=1.5) from 137 kPa and 38 degrees C to state 2, constant pressure from state 2 to state 3 and constant volume from state 3 to state 1. The heat rejected is 1560kj/kg and the substance is ..

User Account

All Pages