Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Materials handling and hoisting
Design Project
Note:Just need detail calculations ,no need to describe the theory part ,need only calculations and assumptions and reasons for assumptions
YOU have to design a conveyor belt to haul ore, density 1500 kg/loose m3, from 400 m underground to surface up a 15° incline in an underground mine. Peak capacity is to be 3000 tonne/hr, belt speed is advised to be 3 m/s. Assume that the drive has automatic take-up, lagged pulley and a 270° arc of contact. The motor drive efficiency is 0.83.The design should include (but is not limited to):a. Selection of the belt typeb. Belt widthc. Troughing angleSurcharge angled. Torque and power requirementse. Motor selectionf. Account for starting and stoppingg. Emergency stop proceduresh. Start-up currentsNote: students should list any assumptions made.
A rotametcr is a volumetric flowmeter that consists of a tapered glass tube that contains a float as indicated in Fig. P3.29 and Video V8.13. The scale reading on the rommeter shown is directly proportional to the volumetric flowrate. With a scale..
Saturated steam at 230 degrees F, 20.78 psia and 19.386 ft cubed per pound of mass enters a compressor with an internal energy of 108.26 Btu/lb of mass and is compressed to 80 psia. the mass flow rate is 50 lb mass per hour. Heat loss from the compre..
What variables would you measure (and feedback through suitable controllers) in order to improve the performance of the control system?
three lbm of air at 300 f and 100 psia expands to twice its original volume in an adiabatic process carried out in a
Design a suitable vibration isolator, consisting of a mass, spring, and damper, as shown in Fig. 9.54(b), for the milling machine such that the maximum vertical displacement of the milling cutter, relative to the horizontal surface being machined,..
Determine the probable production in cubic yard bank measure (bey) for a 2-cy dragline when excavating and casting tough clay.
Steam enters the turbine of a simple vapor power plant with a pressure of 10 MPa and temperature (T), and expands adiabatically to 6kPa. The isentropic turbine efficiency is 85%. Saturated liquid exits the condenser at 6 kPa and the isentropic pump e..
Determine the force in member BC. After the truss is sectioned use a single equation of equilibrium for the calculation of each force. State if these member is in tension or compression. Take F1 = 2 kN , F2 = F3 = 3.8kN , F4 = 5 kN, F5 = 3 kN.
steam is expanded in an adiabatic turbine from a single inlet to a single oulet during an internally reversible
Find the compression ratio, cutoff ratio, the thermal efficiency, the mean effective pressure, and the P -v and T-s diagrams clearly showing all corners.
Why is a combination of torque and angle measurement or control so popular in mass production operations? What is meant by window control?
Explain why the accuracy and the speed of a microcontroller can be increased by increasing the word size of the microprocessor and by addressing one word, and not one byte, at a time. How many memory locations (words in a word-addressable machine)..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd