Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Water is the working fluid in a regenerative Rankine cycle with one closed feed water heater and one open feed water heater. Steam enters the turbine at 1400 psi and 1000 F and expands to 500 psi, where some of the steam is extracted and diverted to the closed feed water heater. Condensate exiting the closed feed water heater as saturated liquid at 500 psi undergoes a throttling process to 120 psi as it passes through a trap into the open feed water heater. The feed water leaves the closed feed water heater at 1400 psi and a temperature equal to the saturation temperature at 500 psi. The remaining steam expands through the second-stage turbine to 120 psi, where some of the steam is extracted and diverted to the open feed water heater operating at 120 psi. Saturated liquid exits the open feed water heater at 120 psi. The remaining steam expands through the third-stage turbine to the condenser pressure of 2 psi. The turbine stages and the pumps each operate adiabatically with isentropic efficiencies of 85%. Flow through the condenser, closed feed water heater, open feed water heater, and steam generator is at constant pressure. The net power output of the cycle is 1e9 Btu/hr. Determine for the cycle:
a) The mass flow rate of steam entering the first stage of the turbine in lb/h.
b) The rate of heat transfer, in Btu/h, to the working fluid passing through the steam generator
c) The thermal efficiency
multi-stage flash distillation is used to desalinate seawater so it is fit for human consumption. a flash distillation
As shown, a 3.1-lb ball is suspended at point D inside a box with dimensions w=9.50 ft, d=6.50 ft, and h=4.50 ft. The ball is held in place by three cables anchored at points A,B, and C on the surface of the box.
at 45 degrees celsius latitude the gravitational acceleration as a function of elevation z above seas level is given by
what is an exergy factor? 8 what is a pinch point and what is it used for? 9 what does the compressor in figure 2 do?
the pin c will support a force of 24 knmagnitude.Based on this criterion, you are asked to determine the largest mass m that the frame can safely support.the diameter of pulley at d is given as 0.2 m.find maximum mass m that can be supported by fr..
a compactor is a press that is employed to crush bulky material into a smaller volume. the system shown uses a
air at 200 kpa and 950 k enters an adiabatic nozzle at low velocity and is discharged at a pressure of 80 kpa. if the
a helical compression spring is made of no. 18 .0147 in wire having a torsional yield strength of 108 kpsi. it has an
the shaft of a gearbox is coupled through a no. 60 chain drive rotating a concrete mixer at 180 rpm clockwise. the
determine the required size for a square bar to be made from aisi 1213 cold-drawn steel. it carries a constant axial
a novel heat engine is being considered for producing work from the thermal energy contained in the wastewater
a piston-cylinder device contains 0.85 kg of refrigerant-134a at -10 degree celsius. the piston that is free to move
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd