Kinetic energyof the ball at the highest point of its motion

Reference no: EM13563962

An outfielder throws a1.91 kgbaseball at a speed of 68 m/s and an initial angle of54.6degrees. What is the kinetic energyof the ball at the highest point of its motion?

Reference no: EM13563962

Questions Cloud

The rotor assembly about the axis of rotation : Each of the three helicopter rotor blades shown in Fig. 10-67 is5.20 m long and has a mass of 153 kg. The rotor is rotating at 202rev/min. (a) What is the rotational inertia of the rotor assembly about the axis of rotation

Pressure on the end of the cylinder due to the applied force : A cylinder with a diameterof 0.240 m is placed between the plates of a hydraulic press asillustrated in the drawing. A 4.45 × 105-N forceis applied to the cylinder. What is the pressure on the end of the cylinder due to the applied force?

What is the voltage across the resistor : A fully charged capacitor with a voltage of 270 kV is discharged through a resistor. What is the voltage across the capacitor at the end of four time constants?

What power must themotor deliver at a instantaneous speed : An elevator has a mass of1170 kg and carries a maximum load of 786 kg. A constant frictionalforce of 4260 N retards its motion upward. Theacceleration of gravity is 9.8 m/s2 .

Kinetic energyof the ball at the highest point of its motion : An outfielder throws a1.91 kgbaseball at a speed of 68 m/s and an initial angle of54.6degrees. What is the kinetic energyof the ball at the highest point of its motion?

A stone was thrown upward with an initial speed : A stone was thrown upward with an initial speed of 10m/s from theroof of a building and strikes the ground in 6s (no air resistance) How tall is the building? How high does the ball go in respect to the roof?

Angle between the current and the voltage of the generator : When a resistor is connected across the terminals of an acgenerator (104 V) that has a fixed frequency, there is a current of 0.505 Ain the resistor. When an inductor is connected across the terminalsof this same generator, there is a current of 0..

Ressure on the end of the cylinder due to the applied force : A cylinder with a diameter of 0.240 m is placed between the plates of a hydraulic press as illustrated in the drawing. A 4.45 × 105-N force is applied to the cylinder. What is the pressure on the end of the cylinder due to the applied force?

Nichrome wire of cross-sectional radius : Nichrome wire of cross-sectional radius 0.791 mm is to be used inwinding a heating coil. If the coil must carry a current of9.25 A when a voltage of 1.20x102 V is applied acroosits ends, find a) the required resistance of the coil and b) the lengt..

User Account

All Pages