Is there enough voltage resolution to not require added gain

Assignment Help Electrical Engineering
Reference no: EM13249020

Design a signal conditioning system to acquire and store a horizontal EOG biopotential. The bandwidth of interest is between 0.5 and 50 Hz and has peak amplitude of approximately +/-1 mV.
-a. Design and draw a block diagram (not circuit) of the signal conditioning portions (everything before ADC) of your system.
-b. Calculate the gain required to optimize you data acquisition into an ADC with desired input range of +/- 5 V.
-c. If you have a 12-bit ADC DAQ-card, what is the resolution of your signal?
-d. Is there enough voltage resolution to not require added gain on the biopotential?

Reference no: EM13249020

Questions Cloud

Prepare a graph that shows total weekly cost for each plan : suppose that the agent expects both daytime and evening calls. at what point (i.e. percentage of call minutes for daytime calls) would she be indifferent between plans A and B?
Find gain in decibels of amplifier that has a straight gain : The controlled variable in a closed-loop system is the direction of a robot arm. Initially, it is at 50o; then it is commanded to go to 25o. What is the error when the arm position is at 15o
What is the overall transfer function in v-amp : In a certain system, an electrical heating element was found to increase the temperature of a piece of metal 7o for each amp of current. The metal expands 0.004 in./deg and pushes on a load sensor that outputs 1 V/0.003 in.
What is the rms voltage of the source : In a series R-L-C circuit, R = 320? , XC = 260? and XL = 600? . The average power consumed in the resistor is 60.0W. What is the rms voltage of the source
Is there enough voltage resolution to not require added gain : The bandwidth of interest is between 0.5 and 50 Hz and has peak amplitude of approximately +/-1 mV. -a. Design and draw a block diagram (not circuit) of the signal conditioning portions (everything before ADC) of your system.
Define what is the minimum external voltage must one supply : What is the minimum external voltage must one supply in orger to perform the electrolsis of molten CaCl_2(l)? Suggest a means for supplying this energy.
Should china revalue the yuan against the dollar : Should China revalue the yuan against the dollar? Why or why not? If so, describe what impact this might have on (1) U.S. balance of payments.
What is the charge on the ion : When an ion accelerates through a potential difference of 2240V, What is the charge on the ion
Define possible structural subunit does the compound contain : A compound's 13C NMR spectrum shows a resonance at 176 and 85 ppm. What possible structural subunit does the compound contain

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Line a goes into an inverter then into a nand gate

Simplify the following circuit. Line A goes into an INVERTER, then into a NAND Gate, then into an OR Gate, then travels into another NOR Gate.

  Calculate the end-to-end propagation time delay

A coaxial line 5.6m long has distributed parameters R=6.5ohm/m, L=3.4 uH/m, G=8.4 mS/m, and C=21.5 pF/m. If the line operates at 2MHz, calculate the characteristic impedance and the end-to-end propagation time delay.

  Give explanation to electric circuits

Explanation to "Electric circuits" question, The voltage across a load is v(t) = 260 sin (377t + 10 °) and the current through the load is i = 100 sin (377t + 10°). What is the RMS power?

  Derive the expression for transfer function

Derive the expression for TRANSFER FUNCTION and write the expression for magnitude and phase of H(f).

  Indicate the use of each memory in the microcontroller

Indicate the use of each memory in the microcontroller (HCS12). In other words, state which one is used for code, program variables, and variables that must remain when the power is turned off.

  Find flux density and electric field in all regions

A volume charge density of K Coulombs per cubic meter resides uniformly within the material of a long cylindrical shell whose inner radius is 1 m and whose outer radius is 3 m. Find D and E in all regions.

  What is the resolution of an 8-bit dac

Which of the following is not an advantage of SPI transmission over SCI transmission Error checking via parity bit Faster transmission Master-slave capability Synchronous transmission A HCS12 embedded timer is in PWM mode.

  Find impedance of scope probe and oscilloscope combination

When the scope probe is properly calibrated, it can be modeled as a 9[M Ohm] resistor in parallel with a capacitor having a capacitance l/9th that of the oscilloscope input capacitance.

  Explain structure and applications of a zigbee network

In a Zigbee network, Coordinators and Routers can't "sleep", i.e. enter a low-power, inactive mode. Why is this What implications are there because of this on the structure and applications of a Zigbee network

  Explain half-wave rectifier

Half-Wave Rectifier, For the half-wave rectifier, the source is a sinusoid of 120 Vrms at a frequency of 60 Hz. The load resistor is 5 ohms. Determine

  What is the generated fis editor in matlab

Develop with MATLAB, a fuzzy control system for controlling the power of a motor (0-350 rpm) based on the supported load (0-1700 lbs) thereby that at greater load develops more power. The system must contain at least 5 rules, but preferably 7.

  Find out the frequency response of receptor

Determine the frequency response of this receptor to stretching. There are devices that can apply sinusoidal stretch to a small segment of tissue.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd