Is the energy of the signal finite and why

Assignment Help Electrical Engineering
Reference no: EM13256364

f(t) = A[u(t) + u(-t/2-5)-1], where u(t) is the unit step function. Is the energy of this signal finite? Why or why not? If it exists, find the energy of this si

Reference no: EM13256364

Questions Cloud

What is the addition to retained earnings : Dividends and retained earnings. Suppose the firm in problem 2 paid out $56,000 in cash dividends. What is the addition to retained earnings?
What is the net income for this firm : Building an income statement. Draiman, Inc., has sales of $795,000, costs of $345,000, depreciation expense of $76,000, interest expense of $41,000, and a tax rate of 35 percent. What is the net income for this firm?
Calculate the average induced emg across ends of the loop : A circular coil of wire with 10 turns and a 4.0 cm radius is located between the poles of a large electromagnet that produces a uniform magnetic field of 0.5T. Calculate the average induced emg across the ends of the loop
Describe the heat capacity of a bomb calorimeter : The temperature increased by 10.08 oC. Use these data, plus the information given below for CO2 and H2O, to estimate the standard enthalpy of formation, of H, at 25 oC for this compound of H values at 25 oC for CO2(g) and H2O(l) are 394 kJ mol 1 a..
Is the energy of the signal finite and why : f(t) = A[u(t) + u(-t/2-5)-1], where u(t) is the unit step function. Is the energy of this signal finite? Why or why not. If it exists, find the energy of this si
Calculate the value of a bond that expects to mature : Calculate the value of a bond that expects to mature in 10 years and has a $1000 face value. The coupon interest rate is 12% that paid semiannually and the investor's required rate of return is 20%.
Explain what was the percentage by mass of mg(oh)2 : What was the percentage by mass of Mg(OH)2 in the original sample. When Mg(OH)2 or Al(OH)3 reacts with HCl(aq), the products are a chloride salt, water and CO2(g)
What is the percentage change in the price of these bonds : Both Bond Bill and Bond Ted have 10.4 percent coupons, make semiannual payments, and are priced at par value. Bond Bill has 5 years to maturity, whereas Bond Ted has 22 years to maturity.
Design bandstop filter to remove noise to limit distortion : An EKG signal is contaminated by 60-Hz noise. Design a bandstop filter to remove this noise while limiting distortion of the EKG signal. Sketch the magnitude and phase response.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate average and reactive powers delivered to the load

A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source. Calculate (a) the average and reactive powers delivered to the load, (b) the peak current, and (c) the load impedance.

  Find the electric field intensity produced by charges

Find the electric field intensity at (0,0,75000) produced by 50,000 0.1 C charges along the x-axis spaced at 1 meter apart starting at (1,0,0) and 50,000 0.2 C chargers along the y-axis spaced at 1 meter apart starting at (0,1,0).

  Explain why the short-circuit method for determining

Explain why the short-circuit method for determining the Thevenin resistance of a circuit cannot be applied if the circuit does not contain any independent current or voltage sources.

  What will the current be when the voltage is increased

1. The current in a circuit is 1 amp. What will the current be when the voltage is increased by 50% 2. A 10ohm resistor is connected across a 12 V battery. How much current is there through the resistor

  Define zener diode

Zener diode, Can You show me how to solve the following: If a 5k resitor is connected between the cathode of a 6.2V ZENER diode and a 12V power supply.

  How many batteries are needed for the project

A student project is required to be portable and hand held. It requires 6 V DC power at a current of 150 mA. The batteries for the power supply must last for a minimum of 7 hours of continuous operation.

  Design an active low pass filter with a cutoff

Design an active low pass filter with a cutoff of 10kHz or more by more than 30db and have the pass band gain positive that does not deviate from 20db by more than 3 db. The pass band frequncy need is 800Hz and below.

  Compute the velocity of the water jet

A hydroelectric power plant has a synchronous generator who's speed must be fixed at 180 r/min. The turbine is Pelton type with 10 m runner diameter. When the flow rate at the nozzle of the penstock is 10m^3/s, the generated electricity.

  Calculate position of the object if distance is given

A microscope has a 2.70-cm focal length eyepiece and a 0.630-cm objective lens. For a relaxed normal eye (assume a viewing distance of 25.0 cm), calculate the position of the object if the distance between the lenses is 13.5 cm

  How does intels architecture differ from mips

how does Intel's architecture differ from MiPS?

  Find what is the maximum power dissipated in the load

What is the maximum power dissipated in the load when the Thévenin voltage is 21 V cos(52 rad/s t + 82°), the Thévenin impedance is 102 -j 184 ohm and the load impedance is 102 + j 184 ohm

  Design synchronous sequential ckt by flip flop excitation

Design a synchronous sequential circuit with one input line and one output line that recognizes the input string x = 1111. The circuit is also required to recognize overlapping sequence such that if the input string is x = 1101111111010

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd