Interference fringes of the two dissimilar patterns

Assignment Help Physics
Reference no: EM13668535

In a double-slit experiment you saw in class the distance among slits is 5.0 mm and the slits are 1.0 m from the screen. Two interference patterns can be seen on the screen, one due to light by wavelength 480 nm and the other due to light with wavelength 600 nm. What is the separation on the screen among the third-order (m = ±3) interference fringes of the two dissimilar patterns?

Reference no: EM13668535

Questions Cloud

An earth satellite in circular orbit : An earth satellite in circular orbit 1100km above earth makes one complete revolution every 75 minutes. What is its linear speed? Use 6400 km for the length of a radius of the earth.
Assuming that each turn of the coil is a square : A generator uses a coil that has 80 turns and a 0.40-T magnetic field. The frequency of this generator is 60.0 Hz, and its emf has an rms value of 120 V. Assuming that each turn of the coil is a square (anapproximation), decide the length of the wire..
Automobile moves by constant speed down a highway : When an automobile moves by constant speed down a highway, most of the power developed by the engine is utilized to compensate for the mechanical energy loss due to frictional forces exerted on the car with the air and the road.
How long will this smoke detector work : The radioactive isotope 241Am, with a half-life of 432 years, is the active element in many smoke detectors. Assume such a detector will no longer function if the activity of the isotope it contains drops below 1/525 of its initial activity. How long..
Interference fringes of the two dissimilar patterns : In a double-slit experiment you saw in class the distance among slits is 5.0 mm and the slits are 1.0 m from the screen. Two interference patterns can be seen on the screen, one due to light by wavelength 480 nm and the other due to light with wavele..
Reflected back to observer and transmitted during glass : We wish to coat a flat slab of glass (n = 1.50) with a transparent material (n = 1.25) and illuminate with light of wavelength 600 nm (in vacuum). For what minimum thickness of the coating will the light be (a) reflected back to the observer and (b) ..
Large heavy disk is mounted to a table by a firm clamp : A large heavy disk is mounted to a table by a firm clamp. A string is wound about an axle on the wheel from which a 100g mass is suspended. The radius of the axle is 0.01m and the large wheel has a mass of 2kg. The noted acceleration is 0.25m/sec2. W..
What is the average power of the elevator motor : A 685-kg elevator starts from rest and moves upward for 2.70 s by constant acceleration until it reaches its cruising speed, 1.75 m/s.  What is the average power of the elevator motor through this period?
Two point-source loudspeakers are a certain distance apart : Two point-source loudspeakers are a certain distance apart, and a person stands 12.0 m in front of one of them on a line perpendicular to the baseline of the speakers. If the speakers emit identical 1000-Hz tones, what is their minimum nonzero separa..

Reviews

Write a Review

Physics Questions & Answers

  Determine what would its maximum height be

In order for a middle to achieve a maximum range of 4,000km what would its maximum height be

  Determine the final velocity of the other puck

Consider the collision between two hockey pucks in the figure below. They do not stick together. Their speeds before the collision are v1i = 27 m/s and v2i = 14 m/s. What is the final velocity of the other puck

  How many slits will the light pass through

You shine violet light through a diffraction grating (200 lines/cm) on a screen 2.0 m from the grating. The width of the light beam is 0.15 mm. How many slits will the light pass through

  Find the angle between the transmitted and reflected rays

A beam of light is incident upon a flat piece of glass (n =1.50) at an angle of incidence of 45 degrees. Find the angle between the transmitted and reflected rays

  Calculate the work done by the gravitational force

A 500kg helicopter ascends from the ground with an acceleration of 2.00m/s^2 over a 5.00second interval, what is the work done by the gravitational force

  What is the change in its internal energy

A gas is compressed at a constant pressure of 0.800 atm from 12.00 L to 3.00 L. In the process, 380 J of energy leaves the gas by heat. (a) What is the work done on the gas? J (b) What is the change in its internal energy?

  What is the magnitude of the charge of the particle

A positively charged particle of mass 6.80 10-8 kg is traveling due east with a speed of 80 m/s and enters a 0.31 T uniform magnetic field. The particle moves through one-quarter of a circle in a time of 1.00 10-3 s, at which time it leaves the fi..

  A thin uniformly chargde rod has a length l10cm and a

a thin uniformly chargde rod has a length l10cm and a linear charge density lambda 5x106 ecm. e is the change of an

  How far has he traveled in this time

A bicyclist is finishing his repair of a flat tire when a friend rides by with a constant speed of 3.6 m/s. Two seconds later the bicyclist hops on his bike and accelerates at 2.2 m/s2 until he catches his friend.

  Explain the function of the activator added in trace

a explain the function of the activator added in trace quantities to many inorganic scintillators. why are activators

  Ball a is dropped from the top of a building of height h at

ball a is dropped from the top of a building of height h at the same instant that ball b is thrown vertically upward

  Question1an unpolarized beam of light is sent into a stack

question1an unpolarized beam of light is sent into a stack of four polarizing sheets oriented so that the angle between

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd