Indicate the frequencies of the recovered modulating signal

Assignment Help Electrical Engineering
Reference no: EM13275679

A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. Assume in a SSB-USB modulated signal that the inserted carrier at the receiver is 200 Hz too high. Indicate the frequencies of the recovered signal (in kHz)

Reference no: EM13275679

Questions Cloud

Find y for a linear time-invariant continuous-time system : A linear time-invariant continuous-time system responds to the following inputs with the corresponding outputs:Ifx(t) = u(t), then y(t) = 2(1- e^-t)u(t) and if x(t) = cost,then y(t) = 1.414 cos(t - pi/4).
What is the benefit of scenario analysis : What is the benefit of scenario analysis if it does not produce an accept or reject decision for a proposed project?
Determine the maximum emf in the alternator : In a 280-turn automobile alternator, the magnetic flux in each turn is ?B = 2.50 multiply.gif 10-4 cos ?t, where ?B is in webers, ? is the angular speed of the alternator, Determine the maximum emf in the alternator
Explain a certain hydrocarbon has a molecular formula : A certain hydrocarbon has a molecular formula of C6H10. Which of the following is not a structural possibility for this hydrocarbon?
Indicate the frequencies of the recovered modulating signal : A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. Assume in a SSB-USB modulated signal that the inserted carrier at the receiver is 200 Hz too high.
What is the financial break-even level for the project : Assume the equipment is depreciated on a straight-line basis over the project's life. What is the accounting break-even level for the project? What is the financial break-even level for the project?
What is the stress in the cylinder : A cylinder of brass has a diameter of 3mm and a length of 100mm. What is the stress in the cylinder
What is the sensitivity of ocf to changes in the variable : What is the sensitivity of OCF to changes in the variable cost figure? Calculate the change in OCF if there is a $1 decrease in estimated variable costs.
Compute the osmotic pressure generated : Calculate the osmotic pressure generated when 12.9 grams of testosterone are dissolved in 168 ml of a chloroform solution at 298 K. what is the molarity and osmotic pressure

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the size of the memory block decoded

An address decoder in a 68000-based microprocessor system selects a memory device when the address lines A23, A22, A21, A20, A19, A18 = 1, 0, 0, 1, 1, 0. What is the size of the memory block decoded and what range of addresses does it span

  Determine weather fm signals can be received inside tunnel

Suppose you are driving inside a tunnel. Assume that each of the two tunnels is 22ft wide and 13.5 ft tall. 1. Can you receive an AM radio signal in an automobile 2. Also determine weather FM signals can be received inside the tunnel.

  Design an iir high-pass filter using bilinear method

design an IIR high-pass filter using bilinear method in a system with sampling frequency of 100 Hz. The lower and higher cutoff frequencies are at 18 Hz and 35 Hz respectively. Pre-warp the cutoff frequencies.

  Find real and reactive power supplied to the 360-v winding

1-phase 2-winding transformer is rated 30 kVA, 360/90 V, 60 Hz. A source connected to the 360-V winding supplies an impedance load connected to the 120-V winding. The load absorbs 15 kVA at 0.8 p.f.

  How to simulate the circuit using verilogger

The circuit will have as inputs a minimum of two inputs; the binary equivalent of two decimal numbers of not greater than (10,000)10. The circuit will also produce a minimum of two outputs, the quotient and the remainder.

  Design lawn sprinkler system to water the lawn of residence

Assume that this whole system is linear, so that, if the pressure on a sprinkler is halved, the area covered (as well as the flow rate) will be halved. This is true until the pressure is reduced below 20psi, at which it does not work at all.

  Derive the dynamic model and average value circuit

Derive the dynamic model and average value circuit of a buck converter assuming the ESRs of the inductor and capacitor are not equal to zero.

  Find output signal y if the frequency responses are given

The signal x(t) = 2 - sin(4.5t - pi / 4) + 3 cos (24t + pi / 2) is input into a system with frequency response H(omega). Find the output signal y(t) if: H(omega) = rect(omega/80) H(omega) = 2 - 2rect(omega/8) H(omega) = sin c(omega/20)

  Obtain input value from two switches on the logic designer

Design a circuit that, given a 2-bit value, will light a LED corresponding to that value. One of four LEDs should be lit for each of the four possible input values (binary 0 through 3).

  Consider a communications channel with a passband

Consider a communications channel with a passband of 3 kHz to 27.4 kHz. A modem will be connected to this communications channel and the modem will operate with a signaling rate that is 0.56 the maximum allowable signaling rate for this communicat..

  Determine the first seven samples of the system output

A FIR filter is depicted in the figure below. Assume that the system is at rest and an input sequence is applied to the system. Determine the first seven samples of the system output Assume that the system is initially at rest. x(n)=u(n)+u(n-1)-2u..

  Determine probability of finding particle between the limits

The solutions to Schrodinger's wave equation for a particular situation is given by Psi(x) = sqrt(2/ao)*e^-x/ao. Determine the probability of finding the particle between the following limits: (a) 0

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd