Implement using d flipflops-and gates or gates and inverters

Assignment Help Electrical Engineering
Reference no: EM13282692

A sequential circuit for a luggage lock has 10 push buttons labeled0,1,2,3,4,5,6,7,8,9. Each pushbutton 0 through 9 produces a 1on X_i, i=0 through 9 with all other values on variable X_ j, jdoes not equal i, equal to 0. Also, these ten pushbuttons produce apositive pulse on the clock C for clocking the flip-flops in thecircuit. The circuitry that produces the X_i signals and theclock C has already been designed. The lock opens in responseto a sequence of four X_i values, i=0 to 9, set by the user. The logic for connecting the four selected X_i values to variablesX_a, X_b, X_c, and X_d has also been designed. Thecircuit is locked and reset to its initial state by pushingpushbutton LOCK, which provides L, the asynchronous reset signalfor the circuit. The lock is to unlock in response to thesequence X_a, X_b, X_c,X_d, regardless of all past inputs appliedto it since it was reset. The circuit has a single moore typeoutput U which is 1 to unlock the lock and 0 otherwise.

Design the circuit with inputs X_a, X_b, X_c, X_d, reset L, clock Cand output U.
Use a 1-hot code for the state assignment.
Implement using D flipflops, AND gates, OR gates and inverters.

Reference no: EM13282692

Questions Cloud

What is the diffraction angle of the sound : The entrance to a large lecture room consists of two side-by-side doors, one hinged on the left and the other hinged on the right. What is the diffraction angle of the sound under each of the following situations
Explain the van der waals equation for n moles of a gas : The van der Waals equation for n moles of a gas is (p+(((n^2) (a))/V^2 ))(v?nb)=nRT where p is pressure, V is Volume, and T is the temperature of gas. The constant R is the universal gas constant and a and b are positive constants that are charact..
Calculate the sustainable growth rate for the firm : A firm has a debt ratio of 45%, capital intensity ratio is 1.3 times, profit margin is 10%, and dividend payout ratio is 30%. Calculate the sustainable growth rate for the firm.
Find the hole density np in a doped gaas : A sample of lightly doped GaAs has a room temperature conductivityof 4.04X10-9[S/cm]. If it is known that the electron andhole mobilities areμn=8500[cm2/V·s], andμp=400[cm2/V·s],respectively
Implement using d flipflops-and gates or gates and inverters : A sequential circuit for a luggage lock has 10 push buttons labeled0,1,2,3,4,5,6,7,8,9. Each pushbutton 0 through 9 produces a 1on X_i, i=0 through 9 with all other values on variable X_ j, jdoes not equal i, equal to 0.
Use the multisim program to make the circuit : Please make sure that you use the Multisim program to make the circuit and can you mention all your step in the report. Write it with simple words.
What is the change in entropy of the boiling water : A pot of hot water is boiling on your stove. The pot is in the shape of a round cylinder made of aluminum which is 10 cm in radius. What is the change in entropy of the boiling water
Which point is at the higher potential : Charge Q = 10E-8 C is placed in the origin. Location A is -3.00m from the charge while location B is 2.00m from the charge. Which point is at the higher potential
How the u.s. financial markets impact the economy : Describe how the U.S. financial markets impact the economy, businesses and individuals. Explain the role of the U.S. federal reserve, the federal reserve chairman, the board, indicating it's effectiveness in today's ecnomic environment, provide su..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the magnitude and phase angle of terminal voltage

Assuming that the secondary is open-circuited and that the primary is connected to a 13.8-kV source, calculate the magnitude and phase angle (with respect to the high-voltage source) of the voltage at the secondary terminals.

  Calculate the resistance of the wire-r between the ends

A cylindrical metal wire of radius r1 and conductivity of o1 has a core region of radius r2 replaced along the whole length with a metal conductivity of o2. Calculate the resistance of the wire, R, between the ends.

  What are the majority and minority carrier concentrations

A silicon sample is 85x10^-6 m in length and has a cross-section of 20x10^-6 m x 6x10^-6 m. It has been uniformly doped with Arsenic with a doping density of 4.5x10^15 cm^-3. Assume the temperature is 300K and mobilities are u_n = 1300 cm^2/Vs and..

  What are combustor inlet temperatur and turbine exhaust temp

A regenerative gas turbine has compressor and turbine discharge temperatures of 350K and 700K respectively. Draw and label schematic and T-S diagrams showing the relevant states.

  What are the number of quantization levels

if the analog signal to be quatized is a sinusoidal wave form x(t)=9.5sin(2000*pi*t), and if the bipolar quatizere uses 6 bits - what are the number of quantization levels - quantization step size or resolution, delta, assuming the signal range

  Find the maximum power available from the source

A practical source delivers 50mA to a 300Ω load. The source delivers 12V to a 120Ω load. Find the maximum power available from the source.

  Calculate armature voltage va to be applied in steady state

If the motor is driving a load whose torque requirement remains constant at 3Nm, independent of speed. Calculate the armature voltage Va to be applied in steady state, if the load to be driven at 1500RPM.

  What must the smaller resistor to be adjusted

An op-amp has an open-loop gain of 200 V/V. If this op-amp is used to build an inverting amplifier with an absolute gain of 50V/V: (a) What must the smaller resistor be adjusted to, if the larger resistor is 100 k

  What is the relative permittivity of si at the wavelength

An ND:YAG laser in the lab emits light at 1064 nm. The laser is light is directed into a slab of silicon, which has an index of refraction n = 4. a. What is the relative permittivity of Si at this wavelength (Hint: Si is non-magnetic.)

  Explain what is the pattern formed in the photoresist

Gratings are often written into photoresist by interference (superposition) of optical beams. In other words, the standing wave formed by the overlap of multiple plane waves produces a (useful) exposure pattern.

  Find the impulse response in n domain

The transfer function (TF) of a system is given below. Find its impulse response inn domain. Hint: First multiply the TF by the z-transform of input-or x(z)-or the z-transform of unit impulse. Factor the denominator and then expand.

  Finding appropriate source for the electrical load

Finding appropriate source for the electrical load, Have four circuits. One takes 9Vdc, two 5Vdc, and last one takes 12Vdc. Have variable transformer for source. How do I calculate or choose the voltage needed to run all four circuits with out blo..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd