User Account

All Pages

If this house were heated instead by a heat pump that has

Assignment Help Mechanical Engineering
Reference no: EM13628027

A house that was heated by electric resistance heaters consumed 1200 kWh of electric energy in a winter month. If this house were heated instead by a heat pump that has an average COP of 2.4, determine how much money the home owner would have saved that month. Assume a price of 8.5¢/kWh for electricity.

Reference no: EM13628027

Questions Cloud

What is the anguar momentum of the disk if it rotates about : a solid disk of mass m3kg and radius r.05m rotates around an axis which is perpendiuclar to the plane of the disk and
A square threaded power screw has a lead angle lambda of : a square threaded power screw has a lead angle lambda of 15o. will the screw be self-locking if it is used in
In order to accumulate enough money for a down payment on a : in order to accumulate enough money for a down payment on a house a couple deposits 415 per month into an account
A 85 kg object undergoes an acceleration of 23 ms2 a what : a 8.5 kg object undergoes an acceleration of 2.3 ms2.a what is the magnitude of the resultant force acting on it?b if
If this house were heated instead by a heat pump that has : a house that was heated by electric resistance heaters consumed 1200 kwh of electric energy in a winter month. if this
A relief valve is installed on the tank to keep the : a tank with volume 3.0m3 contains steam at 2mpa and 280 c. the tank is heated until the temperature reaches 440 c. a
Sppose xn432 using the standard normal table find the : suppose xn432. using the standard normal table find the probabilities. 1 p-2.5 less than or equal to x which is less
If you assume the atmosphere to be pure carbon dioxide : the surface pressure of venus is about 90 bar and the surface temperature is ap-proximately 880 degrees f. the
Determine the maximum steady-state hay temperature for dry : large cylindrical bales of hay used to feed livestock in the winter months are d2m in diameter and are stored

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  What is the corresponding change in heat flux through the

consider a roof of a house of thickness l 20 cm thermal conductivity k 1 wm k and emittance of the external surface

  What is the k.e. of the satellite

A satellite has been placed in a circular, sun-synchronous orbit at an altitude of 1300.0 km. The satellite has a mass of 5,000.0 kg. What is the K.E. of the satellite?

  Determine the rate of diffusion of cu in al at 300k using d

determine the rate of diffusion of cu in al at 300k using d do exp -edrt where do 0.15 cm2sec and ed 125 kjmole.

  Te local acceleration of gravity is 981 ms2 determine the

a gas is contained in a vertical frictionless pixton-cylinder. the piston m 10 kg a- 7.5 x 10-3 m2 is attached to a

  Determine 1 the pressure and specific volume at the initial

determine the specific volume of superheated water vapor at 15mpa and 350oc using a the ideal gas equation b the

  A certain body is weighed at an elevation of 30000 ft where

a certain body is weighed at an elevation of 30000 ft where g32.08 ftsec2 by a spring balance that was calibrated at

  What is the first order angular separations

The hydrogen spectrum has a red line at 656 nm and a blue line at 434 nm. What is the first order angular separations between these two spectral lines obtained with a diffraction grating that has 4500 lines per centimeter?

  The ultimate strengths in tension and compression are 210

a thin-walled cylindrical pressure vessel of 250 mm internal diameter and 5 mm thickness is subjected to an internal

  Water pressure of 10 kpa is pumped to a pressure of 4mpa

water pressure of 10 kpa is pumped to a pressure of 4mpa. what is minimum energy requirement of the pump in kjkg.

  A 04 w cylindrical electronic component with a diameter of

a 0.4 w cylindrical electronic component with a diameter of 0.3 cm and length 1.8 cm is mounted horizontally on a

  Calculate the speed of load g

Wheel of radius r is driven by an arm OA. It is driving (without slip) wheel of a radius r2 which is fixed to a drum of radius r1. Load G is attached to the rope which winds on the drum. Calculate the speed of load G if the arm OA moves at n rev/m..

  Evaluate the fourier coefficients a0 a1 a2 b1 and b2 could

a single cycle of a ramp function of voltage versus time has the form vt 100t from -0.01 to 0.01 s. using direct

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd