If 5000 mw of thermal energy are added to the water in the

Assignment Help Mechanical Engineering
Reference no: EM13631083

A thermal power station operates on the following cycle . Water is pumped into a boiler where it is converted to high pressure , hightemperature steam turbine that addition from the combustion of coal . the steam is expanded in a steam turbine is condensed back to water in a condenser by rejecting heat before it is pumped back to the boiler .

a) Identify the signs of the heat and work transfer interaction occurring during the cycle , taking the water/steam as the system ?

b) If 5000 MW of thermal energy are added to the water in the boiler , 3500 MW are rejected in the condenser , and the additional heat losses from the cycle are 500 MW , what is the net power plant ? what is the thermal efficiency of the power plant ?

c) If the pump power is 1000 kW , what is the turbine power output ?

Reference no: EM13631083

Questions Cloud

When an ac source is connected across a 150 omega resistor : when an ac source is connected across a 15.0 omega resistor the rms current in the resistor is 7.10 a.a find the rms
Determine the equivalent state of stress on an element at : determine the equivalent state of stress on an element at the same point oriented 45 degrees clockwise with respect to
A steam turbine operates with 16 mpa and 350o c steam at : a steam turbine operates with 1.6 mpa and 350o c steam at its inlet and saturated vapor at 30o c at its exit. determine
What will the coriolis force observed on a 600 gram : consider children playing on a merry go around that is 6m in diamter turning at 10 revelutions per minute. what will
If 5000 mw of thermal energy are added to the water in the : a thermal power station operates on the following cycle . water is pumped into a boiler where it is converted to high
A string of length 12m vibrates in 7 loops at a frequency : a string of length 1.2m vibrates in 7 loops at a frequency of 70hz. show worka. what is the wavelength?b. at what
Oxygen enters an insulated 12-cm-diameter pipe with a : oxygen enters an insulated 12-cm-diameter pipe with a velocity of 70 ms. at the pipe entrance the oxygen is at 240 kpa
Suppose that the magnetic field of the earth were due to a : suppose that the magnetic field of the earth were due to a single current moving in a circle of radius 2910 km through
The hose ends with a nozzle of diameter 240 cm a rubber : a village maintains a large tank with an open top containing water for emergencies. the water can drain from the tank

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  At what time does the hour hand point in the same direction

a clock face has negative point charges -q -2q -3q middot middot middot -12q fixed at the positions of the

  Discuss the key motivations leading to the three classes of

problem 1explain the role of the fiber-matrix interface strength in the fracture toughness of fiberreinforced ceramic

  Five kg of water is contained in a piston-cylinder assembly

five kg of water is contained in a piston-cylinder assembly initially at 5 bar and 240degc. the water is slowly heated

  What is the percentage error

One side of a right triangle is known to be 45 cm long and the opposite angle is measured as 30?, with a possible error of 1?.

  Advanced stress analysisin all but a very few vehicles

advanced stress analysisin all but a very few vehicles today crush or crumple zones are employed as a method to reduce

  After pumping stops and a new equilibrium is reached the

after pumping stops and a new equilibrium is reached the tire pressure is 600 kp a and the air temperature in the tire

  Slow expansion is performed while there is heat transfer

a pistoncylinder contains water with quality 75 at 200 kpa. slow expansion is performed while there is heat transfer

  A power drive shaft is designed with a safety factor of 8

a power drive shaft is designed with a safety factor of 8. the shaft is subjected only to torsional load torque. if the

  Suppose that a wing component on an aircraft is fabricated

suppose that a wing component on an aircraft is fabricated from an aluminum alloy that has a plane strain fracture

  The exit temperature of the water is 25oc then what is the

an adiabatic heat exchanger has 0.3 kgs of water passing through one flow path. the inlet temperature and pressure are

  Air at 110 kpa and 250 k is compressed steadily to 570 kpa

air at 110 kpa and 250 k is compressed steadily to 570 kpa and 400 k. the mass flow rate of air through the compressor

  Consider a steam turbine where steam enters with a

consider a steam turbine where steam enters with a pressure of 10 mpa and temperature 500 degc and expands

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd