Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 0.20 wt% carbon steel gear was pack carburized and carbon concentration at the surface was increased to 0.8wt%, and subsequently heated and held in the austenitic temperature range until complete transformation to austenite occurred. The gear was quenched in water; how would this treatment affect the following properties: (3)
a. Strength at the surface:
b. Hardness at the core:
c. The most probable microstructure/phase at the surface (identify):
Two solid cylindrical rods AB and BC are welded together atB and loaded as shown
A fan with a diameter of 12 inches operates at a voltage of 120V with a current draw of 0.5 amps. The manufacturer claims the average velocity of air leaving the fan is 33.1 ft./s under stadard conditions. Standard air has a density of 0.075 lb mass ..
refrigerant 134a flows at steady state throught a horizontal pipe having an inside diameter of 4 cm entering as
a power plant using steam as the working fluid operates on a rankine cycle. the temperature at the condenser exit is
Explain why adaptors are usually needed when systems are constructed by integrating COTS products. Suggest three practical problems that might arise in writing adaptor software to link two COTS application products.
an ideal carnot heat engine has an efficiency of 40. if the high temperature is raised 15 what is the new efficiency
Consider subsonic flow in a converging nozzle with fixed inlet conditions. What is the effect of dropping the back pressure to the critical pressure on?
As the hollow steel (G = 77 GPa) shaft shown rotates at 180 rpm, a stroboscopic measurement indicates that the angle of twist of the shaft is 3°. Determine
Also find out a compression ratio and inlet pressure to give maximum imep. engineering fundamentals of internal combustion enignes - pulkrabek.
Describe the theory used for the IZOD test and what units are used to report toughness? Explain the change in magnetic properties when steel is heated. Is this due to allotropic properties?
a regenerative steam cycle operates between the limits of 80 bar 540oc and 0.05 bar. if only one extraction from the
Describe a possible method to estimate the activation energy of densification during liquid phase sintering.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd