How would the phase voltage at starting compare

Assignment Help Electrical Engineering

Reference no: EM131203077

In this chapter, we learned that a step-down autotransformer could be used to reduce the starting current drawn by an induction motor. While this technique works, an autotransformer is relatively expensive. A much less expensive way to reduce the starting current is to use a device called Y-D starter (described earlier in this chapter). If an induction motor is normally D-connected, it is possible to reduce its phase voltage Vf (and hence its starting current) by simply re-connecting the stator windings in Y during starting, and then restoring the connections to D when the motor comes up to speed. Answer the following questions about this type of starter.

(a) How would the phase voltage at starting compare with the phase voltage under normal running conditions?

(b) How would the starting current of the Y-connected motor compare to the starting current if the motor remained in a D-connection during starting?

Reference no: EM131203077

Questions Cloud

What might the consultant have done differently : What did the organizational consultant do right in the assessment of corporate culture? What might the consultant have done differently? What was the most surprising finding of the cultural assessment?

What is its diameter in inches : What is the area in circular mils of an aluminum conductor that is 80 ft long with a resistance of 2.5Ω? - What is its diameter in inches?

What is the slip of the motor at this time : The power crossing the air gap of a 60 Hz, four-pole induction motor is 25 kW, and the power converted from electrical to mechanical form in the motor is 23.2 kW.

What is the resistance of a copper wire : What is the resistance of a copper wire 200 ft long and 0.01 in. in diameter (T = 20°C)?

How would the phase voltage at starting compare : How would the starting current of the Y-connected motor compare to the starting current if the motor remained in a D-connection during starting?

What is the diameter of each wire in inches : The area in circular mils is 1600 CM, 900 CM, 40,000 CM, 625 CM, 7.75 CM, 81 CM. - What is the diameter of each wire in inches?

Design on model- based testing : Binder et al. research design on Model- Based Testing was based on positivists approach (Easterby-Smith, 2012), here the researchers want to deduce the efficiency and effectiveness of MBT based on users' experiences Where Does It Stand? By Roberty..

How the laws are structured and the content of the laws : Compare and contrast the Hebrew Ten Commandments with the law code of Hammurabi. In what ways are they similar and different? Here you should focus on such topics as how the laws are structured, the content of the laws, and the use of religion t..

Calculate the area in circular mils of wires : Calculate the area in circular mils (CM) of wires having the following diameters: - 0.050 in, 0.016 in, 0.30 in, 0.1 cm, 0.003 ft, 0.0042 m.

User Account

All Pages