Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The campus bus uses an embedded system that tracks the number of passengers getting in and those getting out of the bus. Two circuits with laser photodiodes, connected to RB0 (getting in) and RB1 (getting out), are used to track these numbers. At any time, the total number of passengers is equal to the total passengers entering in minus the total of those getting out of the bus. Whenever the total number of passengers in the bus reaches its maximum capacity (assumed equal to 30), the system turns on a red LED (connected to RD1). If the number is under 30, the system turns a green LED (connected to RD0).
a) Write an algorithm for the program
b) Translate the algorithm to a C program
Determine the capacitance required in a half wave rectifier to produce a ripple voltage less than 0.2V. Assume that the input is a 60Hz signal with maximum voltage VM=100V
A three-phase substation transformer operating at 34.5kV is loaded to 24 MVA. What is the per-phase current? (assume balanced conditions)
Each of the capacitance units is built of 4 similar 100V capacitors. Determine the capacitance of each capacitor.
Determine the location of the peaks in the following sampled spectrum for the following sine waves: (a.) signal frequency = 300 Hz; sampling frequency = 1 kHz (b.) signal frequency = 600 Hz ; sampling frequency = 1 kHz
1) Two signals are said to be orthogonal if the integral of the product of the signals is 0 over one period of the new (multiplied) signal. Assume x(t) and y(t) are orthogonal energy signals with energy, Ex and Ey, respectively.
A wafer 100mm in diameter is mounted in an electron-beam evaporation system in which spherical radius is 40cm. Estimate the worst case variation in film thickness between the center and edges of the wafer for an evaporated aluminium 1micro meter t..
The SV curve can be used to understand the impact of constant power factor shunt compensation support. In this case, the receiving end is injected with a specific amount of reactive power so that the receiving end maintains a constant load power f..
Design a combinational circuit with four inputs, x,y,w, and z, and four outputs: A, B, C, and D. When the binary input value in decimal is 3,5,6,9,10 or 12, the binary output value is one less than the input value, otherwise it is one greater than..
A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function..
Each start/stop station contains one NO start pushbutton and one NC stop pushbutton.
Write an assembly code segment that calls the subroutine New Function if bits 5 and 6 of PORTD equal 1. Write the same code segment in part (a) using structured assembly constructs.
(a) Determine a unit vector in the direction of Q at P(1, 2, 1) (b) Find the component of Q at P in the direction of PT where T is point (5, 3, -4) (c) Where is Q the same as the unit vector of \(a_{x}+11a_{y}+10a_{z}\)
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd