How to show h in the vector az directions

Assignment Help Electrical Engineering
Reference no: EM13265433

A circular loop of radius 2a lies in z=0 and carries current I in the counterclockwise directions. How do I show H= square of 2 * I divided by pi*a in the vector az directions?

Reference no: EM13265433

Questions Cloud

What must flora show to recover damages from fast delivery : What must Flora show to recover damages from Fast Delivery?
Find the initial and final value of the time function : Use the initial and final value theorems to find the initial and final value of the time function corresponding to the following Laplace transform X(s) = x/(s+1)(s+4)
How low would the interest rate on the loan : How low would the interest rate on the loan with the compensating balance have to be for you to choose it?
Would the breakeven point increase or decrease : Would the breakeven point increase or decrease if the variable costs move from 40% to 45% of sales (all else constant)? Pick one.
How to show h in the vector az directions : A circular loop of radius 2a lies in z=0 and carries current I in the counterclockwise directions. How do I show H= square of 2 * I divided by pi*a in the vector az directions
Foreign direct investment over the foreseeable future : According to the efficient market view, the best predictor of exchange rates. Which of the following are main drivers of rising foreign direct investment over the foreseeable future?
Obtain the total magnification : Two 22.3-cm-focal-length converging lenses are placed 16.5?cm apart. An object is placed 35.0?cmin front of one lens. obtain the total magnification
What is the possible ouput voltage range : the CMRR of a differential votage amplifier is specified as CMRR >10³, its voltage gain is G=50. the two input voltage have values v1=10.3 and v2=10.1.
What are the roots of the well-established : What are the roots of the well-established Italian and Japanese communities living in Sao Paulo today?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the maximum noise power that can be inserted

A radio link has a transmitter with a power of 1 W and an initial noise of 16 mW. The receiver has a sensitivity of 125 mW and can tolerate a SNR of 15 dB. What is the maximum noise power that can be inserted

  Design a circuit which performs error checking on a stack

A stack controller is a digital circuit in a computer that implements last in firstout (LIFO) storage for temporary data. It operates analogously to a stack of plates where you can put a new plate on the top of the stack or you can take a plate of..

  Carefully plot the equivalent impulse response function hp

Two LTIC systems have impulse response functions given by h1(t)=(1-t)[u)t)-u(t-1)] and h2(t)=t[u(t+2)-u(t-2)].a) Carefully sketch the functions h1(t) and h2(t). b) Assume that the two systems are connected in parallel.

  What is regulator output voltage when the supply is high

Design a 7.5-V zener regulator circuit using a 7.5-V zener specified at 12mA. The zener has an incremental resistance r(z) = 30 ohms and a knee current of 0.5mA. The regulator operates from a 10-V supply and has a 1.2k-ohm load.

  Find f on side bc and find f on side ab

A rectangular loop of wire in free space joints point A(1,01,) to point B(3,0,1) to point C(3,0,4) to point D(1,0,4) to point A. The wire carries a current of 6mA, flowing the az direction from B to C. A filamentary curent of 15A flows

  What is the difference between a timer and a counter

The toggle switch has been closed for two minutes. During the first 15 seconds after the closing of the toggle switch, pushbutton I2 was pressed four times. Describe what the status of the motor and the pilot light (PL) will be at the two minute m..

  Explain fundamental periods versus discrete time

A signal x[n] is formed by sampling a signal x(t) = -4sin(200*pi*t) at a sampling rate of 400Hz. Graph x[n] over 10 fundamental periods versus discrete time. Then do the same for the sampling frequencies of 60 and 200Hz.

  What is the baud rate for the multilevel system

A binary waveform of 53000 bits/sec is converted into an 8192 level waveform that is passed through a channel with a raised cosine-rolloff filter characteristic. The channel has a conditioned (equalized) phase response out to 4.0 kHz.

  What is the probability that team c is not successful

A conservative design team C and an innovative design team I are asked to separately design a new product within a month. From past experience, we know  The probability that team I is successful is 1/2  The probability that one and exactly one team..

  Find and plot straight-line approximations to the amplitude

a) Find and plot the straight-line approximations to the amplitude and phase response bode plots b) sketch the approximate amplitude-response bode plot od this system using the straight-line approximation and approximate amplitude values at the br..

  What is the value of the total circuit complex impedance

An input signal of 10V at 0degrees and a frequency of 1592Hz is applied to a series RLC circuit with resistor R=100ohm, inductor L= 40mH, and a capacitor C=0.5uF. The value of the total circuit complex impedance is

  What is corresponding gate length for mos transistors

What is the (approximate) maximum electric field intensity for which constant mobility may be assumed for electrons in silicon. In a digital circuit with a supply voltage of 1V, what is the corresponding gate length for MOS transistors.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd