How to add a third tone to the modulating signal

Assignment Help Electrical Engineering
Reference no: EM13250684

Experiment by changing the amplitudes of the modulating tones, and by adding a third tone to the modulating signal. First establish what you
expect , then confirm by computer simulation. For example, ask yourself: What will happen if A is increased?
Then verify the answer numerically.

Reference no: EM13250684

Questions Cloud

Determine the work done by normal force : Starting from rest, a 4.10-kg block slides 2.6 m down a rough 30.0° incline. The coefficient of kinetic friction between the block and the incline is ?k = 0.436, Determine the work done by normal force
The alcohols can be dehydrated to alkenes with sulfuric acid : Alcohols can be dehydrated to alkenes with sulfuric acid and alkenes can be used to prepare alcohols using sulfuric acid detail both mechanisms and explain the differences
An aircraft has constant roll angle : An aircraft has constant roll angle of 10 degrees and pitch angle 10 degrees, and a constant yaw rate of 6 deg/sec. Calculate the body components of the aircraft’s angular velocity:
What kind of session did royce attend : He, along with 58 of his coworkers, is in line for a promotion next year. Attending this session was a recommended step. What kind of session did Royce attend?
How to add a third tone to the modulating signal : Experiment by changing the amplitudes of the modulating tones, and by adding a third tone to the modulating signal. First establish what you expect , then confirm by computer simulation.
Compute the solubility of mx in strong acid : For the compound MX, Ksp is 2.00 × 10-11. The anion X- forms the weak acid HX (Ka = 1.8 × 10-5). Calculate the solubility of MX in 10.00 M strong acid.
By what percentage can the energy consumption be reduced : Suppose that the cost of electrical energy is $0.12 per kilowatt hour and that your electric bill for 30 days is $60 (power usage only, not including other charges or taxes) Assume that the power delivered is constant over the entire 30 days.
Select the most likely pattern for the crystal field : Choose the most likely pattern for the crystal field diagram for the complex trans-[Ni(NH3)2(CN)4]2-, where CN- produces a much stronger crystal field than does NH3.
Find the maximun voltage across the capacitorat resonance : a 100 ohm resistor, a 0.100micro F capacitor, and a 300mH conductor are connected in series to a voltage source with amplitude 240 V, hat is the maximun voltage across the capacitorat resonance

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Estimate of the maximum fundamental operating frequency

Using the LM555 data sheet, make an estimate of the maximum fundamental operating frequency in the astable mode.

  What is the maximum range of the police radar unit

A police K-band radar is operating, with transmit power of 1000 Watts and antenna gain of 300 in linear units. The radar unit is designed to detect a target with a radar cross-section (RCS) of 6 sq. meters and its receiver can detect a signal

  Design a phase shift circuit at a frquency

1- Draw a circuit whose output goes to + V sat . When the input signal is below -4V. the output should be -V sat, when the input is above - 4V  2- Design a - 90 phase shift circuit at 1590 Hz , Then for your design calculate 0 at 15 Hz, & 15 KHz

  Calculate the average voltage across the load

A single-phase, half-wave SCR circuit is used to control the power consumption of an inductive load. The resistive component of the load is 5 Ohm. The source voltage is 120 V (rms). When the triggering angle is adjusted to 60 degrees

  Calculate the annual saving in electrical usage in us

induction cooking based on power electronic is estimated to be 80 percent efficient compared to 55 percent for conventional electric cooking . if an average home consumes 2 kw-hrs daily using conventional electric cooking.

  Find the total line current and the resultant power factor

A three phase load draws 100kW at a poer factor of 0.7 laggaing from a 220V line to line. In parallel with this load is a three phase capacitor bank which draws 60kVAR. Find the total line current and the resultant power factor.

  What is the maximum average power the source can output

A current source of value 2cos(2t) A is used to power a string of 2W lightbulbs. If you wanted to replace this current source with a DC one, but have the same power drop, what DC current should you apply (one decimal place needed)

  How long does it take light from sun to reach neptune

The average orbital radius of Neptune is 2.8 billion miles. Given that distance, how long on average does it take light from the sun to reach the planet Neptune in hours (Speed of light in English system = 186,282.4 miles/second)

  Detailed explanation to op-amp

Detailed Explanation to Op-Amp, A certain op-amp has an open-loop voltage gain of 100,000 and a common mode gain of 0.2. Determine the CMRR in dB.

  Find the three quartiles and the interquartile range

A. determine the mean, variance, and standard deviation B. find the three quartiles and the interquartile range C. Prepare a box plot for the data and determine if there are any outliers present.

  What is specific application or product involve z-transform

What is specific application or product that might involve the z-transform and how is it relevant in the application or design of the application or porduct

  Calculate the total resistance and leakage reactance values

The transformer secondary is now connected to a purely resistive load drawing 50A. Calculate: a) the total resistance and leakage reactance values referred to the secondary (Rt2 and Xt2), b) the output voltage, c) the output power, VA and Vars,

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd