How much power the station will be delivering then

Assignment Help Electrical Engineering
Reference no: EM13280394

You are the operator of a 15,000 V 60 Hz electrical substation. When you get to work one day you see that the station is delivering 6.0 MW of power with a power factor cosf=0.9. What is rms current? How much capacitance you should add in series to bring the power factor to 1.0? How much power the station will be delivering then.

Reference no: EM13280394

Questions Cloud

Define what is the final temperature of water : A 23.45g piece of iron and a 29.95g piece of gold at 100.00C were dropped into 530ml of water at 16.05C. The molar heat capacities of iron and gold are 25.19 (j/mol x C) and 25.41 j/(mol x C). respectively. What is the final temperature of water a..
What is the radius of the sphere : A uniformly charged sphere has a potential on its surface of 450 V. What is the radius of the sphere
With what speed does the mass exit the rough region : A spring (k=100N/m) is squished x=.40 m with a mass m=1 kg held against it. With what speed v does the mass exit the rough region
Define e for each chemical reaction : Calculate E for each chemical reaction that produces 943 kJ of heat but does no work on its surroundings.
How much power the station will be delivering then : You are the operator of a 15,000 V 60 Hz electrical substation. When you get to work one day you see that the station is delivering 6.0 MW of power with a power factor cosf=0.9. What is rms current.
Which end of the wing is positive : Consider a Boeing 777-200 airplane of wing span 60.93 m cruising horizontally at Mach 0.785 (about 828 km/h) due north in a region where the earth's magnetic field is .98*10
Explain shuttle employs a mixture of aluminum : The reusable booster rocket of the U.S. space shuttle employs a mixture of aluminum and ammonium perchlorate for feul. the chemical reaction that occurs is
Find the expression for the magnetic field strength : A switch closes at t=0 and the capacitor is discharged through the wire with 1 Ohm resistance. Find the expression for the magnetic field strength inside the capacitor 1 cm from the axis as a function of time. Draw the graph of B versus t.
Evaluate e for a system that absorbs of heat : Calculate E for a system that absorbs 814.0 kJ of heat from its surroundings and does 676.0 KJ of wor on its surroundings.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How many turns are required to produce an inductance of 1 mh

A square cross section, air filled toroid has Inner radius 12 cm. outer radius 14 cm. and thickness 2 cm. How many turns are required to produce an inductance of 1 mH

  What is probability of downloading time for software is more

The time taken to download software from the internet is uniformly distributed between four and ten minutes. A. What is the probability that the downloading time for software is more than six minutes B. Prob that time is between five and eight minute..

  Find expression for the slip at which maximum torque occurs

The expression for the torque of an induction motor as a function of its slip may be obtained by application of Thevenin's theorem to the circuit model. Show that the Zth obtained can be shown to be approximately equal to Zth = R1+JX1

  Define design a synchronous counter using j-k flip-flops

Design of sync counter 0010 to 1101 using JK flip flops, Design a synchronous counter using J-K flip-flops that will count from 0010 to 1101 repetitively.

  Determine how fast must hit the ball to land at the base

in the bottom of the 9th inning, the bases are loaded and the braves are down by three runs. chipper johns steps to the plate. twice he swings and misses. The crowd heads for the exits. the next pitch is a fast ball down the middle.

  Find the instantaneous and rms value current supplied

A single-phase load is supplied with a sinusoidal voltage v(t) = 200 cos(377t) The resulting instantaneous power isp(t) = 800 + 1000 cos(754t ¡ 36:87±)  (a) Find the complex power supplied to the load.

  What will then be the frequency at which the loop gain given

An op-amp has a single-pole, open loop response with the dc open loop gain of A0=20,000 and the pole frequency at fp=40 Hz. A. If this amplifier is connected as a non-inverting amplifier configuration with the closed loop gain

  How far from the surface must the other probe be placed

A very long insulating cylinder of charge of radius 2.30 cm carries a uniform linear density of 17.0 nC/m . If you put one probe of a voltmeter at the surface, how far from the surface must the other probe be placed so that the voltmeter reads 180..

  What is the amplitude of resulting simple harmonic motion

A 2.19 x 10-2-kg block is resting on a horizontal frictionless surface and is attached to a horizontal spring whose spring constant is 120 N/m. The block is shoved parallel to the spring axis and is given an initial speed of 10.5 m/s

  Find out built-in potential barrier and widths of depletion

A junction is an n region next to an intrinsic region, which can be represented as an ntype region to a p-type lightly doped region. At T= 300K, the doping concentrations in silicon are Nd =1018 cm-3 and Na= 1013 cm-3.

  Find the total energy into the capacitor during the time

The current flowing into a particular capacitor is given by the expression I = 6e^(-0.05t) where I is in Amps and t is in seconds. The voltage across the capacitor during the same time period is given by V = 10-10e^(-0.05t) where V is in Volts.

  Determine how much bandwidth does the system require

Suppose that you wish to offer a voice over IP wireless service. The target packet error rate (or drop rate) is 10^3 and you determine that if the signal is confined to within a coherence band, about 20% of the packets are dropped due to fading.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd