How much heat is inputted into the gas

Assignment Help Physics

Reference no: EM13263346

14g of nitrogen gas at 0°C and 1 atm is compressed in an isochoric process to an pressure of 20 atm.

a) What is the final temperature of the gas?

b) What is the work done on the gas?

c) How much heat is inputted into the gas?

d) Show the process in a p-V diagram

Reference no: EM13263346

Questions Cloud

What is the minimum force must be applied to the plunger : A hypodermic needle is attached to a syringe with a plunger of diameter 1.6 cm. What is the minimum force must be applied to the plunger

What is the radius for the circular plate : A parallel-plate capacitor with circular plates of radius R is being charged. What is the radius R for the circular plate

Find the value of capacitor connected in parallel with load : 120V, 60 Hz source is connected to a distribution line whose resistance, and inductive reactances are 0.1Ohm, j0.2 Ohm, respectively. Single phase, 2HP, 120V, 0.75 lagging pf. motor and 2.4Kw, 120V heater is connected in parallel.

What is the effective annual interest rate : What is the effective annual interest rate on this lending arrangement?

How much heat is inputted into the gas : 14g of nitrogen gas at 0°C and 1 atm is compressed in an isochoric process to an pressure of 20 atm. How much heat is inputted into the gas

What is the minimum output voltage of the discriminator : An FM receiver has a Foster Seeley discriminator that has a transfer ratio K = 0.03v/khz. If the maximum IF deviation is 75Khz, what is the maximum output voltage of the discriminator What is the minimum output voltage of the discriminator

Describe the cruise ship explorer of the seas : In "Excess on the High Seas", Pyper uses comparison to describe the cruise ship Explorer of the Seas. How does this use of comparison aid in conveying the excesses of the cruise ship?

Describe the characteristics of the series rc filter circuit : Describe the characteristics of the series RC filter circuit with the outpu across the resistive component. Distinguish the pass and stop bands with reference to the cutoff frequency. Also state what happens to the circuit complex impedance at the..

What material is the rod made of : The ends of a 20cm long, 2.0cm diameter are maintained at 0°C and 100°C, What material is the rod made of

User Account

All Pages