How much energy is stored in the inductor

Assignment Help Electrical Engineering
Reference no: EM131294069

Assignment

1) Consider the circuit below. Assume the switch has been in its initial position for a long time, and it switches position as indicated at t = 0.

a. Find v(t) for all t > O.
b. Sketch v(t) as voltage vs. time; annotate critical values on your sketch.

2060_Circuit Diagram.jpg

2) Consider the circuit diagram below; assume the switch has been in the initial position for a long time, and it switches position as indicated at t = 0.

a. Find i(t) through the inductor for all t > 0.
b. Sketch i(t) as current vs. time; annotate critical values on your sketch.
c. How much energy is stored in the inductor at t = ∞?

928_Circuit_Diagram.jpg

3) Consider the circuit diagram below, and assume that the circuit is in steady state. Determine:

a. the amount of energy stored in C1I;
b. the amount of energy stored in L3; and,
c. the power dissipated in R1 and R3.

2213_Circuit Diagram1.jpg

4) Consider the circuit diagram below. Find Ix(t) for t < 0 and t ≥ 0.

111_Circuit_Diagram1.jpg

5) Consider the circuit diagram below. Find Ix(t) for t ≥ 0.

243_Circuit Diagram2.jpg

Reference no: EM131294069

Questions Cloud

Discusses gender issues in business : Based on your research, present an article that discusses gender issues in business. Analyze the key points of the article and make suggestions as to areas that need improvement.
Subject-trends current problems air trans : What do you think is the most important challenge to the industry? Is it a new challenge or one that has plagued the industry for decades? Support your response.
Determine the rate of heat loss from the engine : Determine the rate of heat loss from the engine, its entropy production rate and Its entrance and exit specific flow availabilities.
Components of deming profound knowledge : Failure to understand the components of Deming's profound knowledge can create some severe problems. Answer the following three questions to relating Peter Scholtes's observations about the failure to understand Deming's profound knowledge.
How much energy is stored in the inductor : Find i(t) through the inductor for all t > 0. Sketch i(t) as current vs. time; annotate critical values on your sketch. How much energy is stored in the inductor at t = ∞?
Determine the work and entropy production per kilogram : Draw a T-s diagram for the turbine.- Determine the work and entropy production per kilogram of steam flowing through the turbine.
What type of t-test does this represent : What type of t-test does this represent?What is df for this test?If we use a 2-tailed test with a = .05, what is the critical t-value?if we use a 1-tailed test with alpha = .01, what is the critical t-value
Equity investment in the subsidiary using full equity method : Miland Corp. acquired 100% of the stock of Barton Co. on January 1, 2011 for $299,320. On this date, the balances of the subsidiary’s stockholders’ equity accounts were common stock, $182,000, and retained earnings, $19,600. The parent accounts for i..
Focus on its professional services division : In your Conclusion, recommend if The Weather Company should expand its efforts developing consumer apps or focus on its professional services division, offering weather and biometeorological analytics to its business customers. Can TWC effectively..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is a semiconductor

What is a semiconductor? - How does it compare with a conductor and an insulator?

  Explain the rationale for this statement

However, in solving the semisupervised extension of this method, the representer theorem is the right choice. Explain the rationale for this statement.

  Find three-phase reactive power delivered to the load

A wye-connected balanced three-phase source is feeding a balanced three phased load. the phase voltage and the phase current of the source are v(t)=340sin(377t+0.5236) V i(t)=100sin(377t+0..87266) V

  Write the vhdl process statements for a d flip-flop

Write the VHDL PROCESS statements for a D flip-flop with asynchronous active-LOW clear, synchronous active-LOW preset, and responsive to a falling edge clock. Use D for the input, Q and for the output, PRE for the preset, CLR for the clear, and CL..

  Determine what is the power factor of the other load

The two loads draw a total average power of 52,800 W at a power factor of 0.8 leading. One of them draws 40K VA at a power factor of 0.96 lagging. What is the power factor of the other load

  The amplitude of this signal

Question 1. 1. (TCO 1) The signal is 5 sin (2 pi 2000 t + 60 degrees). The amplitude of this signal is        5 VPP        3.535 VPP        3.535 VRMS

  What is the magnitude of the surface charge on dielectric

An empty capacitor has a capacitance of 6.44 µF and is connected to a 12-V battery. A dielectric material (X = 4.5) is inserted between the plates of this capacitor. What is the magnitude of the surface charge on the dielectric

  Determine the value produced at the primary output

Draw a digital circuit consisting of a 2-input AND gate and three inverters, where an inverter is connectedf to each of the AND gate's input and its output. For each of the four possible combinations of inputs applied to the two primary inputs of ..

  Show that the dual of exclusive-or is also its complement

Derive the circuits for a three-bit parity generator and four-bit parity checker using an odd parity bit.

  Determine the frequency response for the lti system

determine the frequency response for the LTI system specified by the LCCDE y[n] - 0.8y[n -1] = x[n]. Plot the magnitude response and phase response for -pie

  Determine what is equilvalent circuit for the combination

Two ideal diodes are placed in series, pointing in opposite directions. What is the equilvalent circuit for the combination What is the equilvalent circuit if the diodesare in parallel and pointing in opposite directions

  Express logic relationship between inputs and outputs

give three methods that are used to express logic relationship between inputs and outputs of a logic gate, for example a three-inputs NOR gate.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd