How much energy is stored in catapult just before release

Assignment Help Electrical Engineering
Reference no: EM13267045

A catapult has two rubber bands, each with a square cross-section with a width 4 mm and length 300 mm. In use its arms are stretched to three times their original length before release. Assume the the modulus of rubber is 10-3 GPa and that it does not change when the rubber is stretched. How much energy is stored in the catapult just before release?

Reference no: EM13267045

Questions Cloud

Depict a lewis structure for ammonia nh3- : Draw a Lewis structure for ammonia NH3-.Show all unshared pairs and formal charges, if any. Assume that bonding follows the octet rule.
What is maximum voltage if current is required to be bigger : A 50-cm-long copper wire with a cross-sectional area 1.2286x10^-10 m^2 is used to connect a voltage source and a device. What is the maximum voltage if the current is required to be not bigger than 5A
Determine the diameter of the hose : Water flowing through a hose at 4.0 m/s fills a 800L child's wading pool in 7.0min. What is the diameter in cm of the hose
Define what is the activation energy for the reaction : if the observed rate constant for the oxidation reaction at 35 C is 6.75*10^-2 min^-1, and at 25 C is 3.25*10^-2 min ^-1. what is the activation energy for the reaction
How much energy is stored in catapult just before release : In use its arms are stretched to three times their original length before release. Assume the the modulus of rubber is 10-3 GPa and that it does not change when the rubber is stretched. How much energy is stored in the catapult just before release
What must the angle of incidence be : A square room has 3 mirrored walls of length L with one side missing. A laser is fired from the center of the open side of the room with an angle of incidence, I, what must the angle of incidence be
What is the risk neutral probability p : A stock is currently priced at $100. Over each of the next two three month periods it is expected to increase by 10% or fall by 10%. Consider a six month call option with a strike of $95. The risk free rate is 8% per annum.
What is the hedge ratio of the put option : Consider a six month put option on a stock with a strike price of $32. The current stock price is $30 and over the next six months it is expected to rise to $36 or fall to $27. The risk free rate is 6%.
What was the proton''s speed as a fraction : The highest-energy cosmic ray ever detected had an energy of about 3.0x10^20 eV. Assume that this cosmic ray was a proton. What was the proton's speed as a fraction of c

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find does sampling frequency meet the nyquist requirement

Five periods of the signal s(t)=sin(2500pi*t) are sampled at a sampling frequency of 4000 Hz. a. Does this sampling frequency meet the Nyquist requirement for the signal? b. How many samples are collected

  What was the bullets speed with frictionless block

A 1.12 kg block is attached to a horizontal spring with spring constant 3500 N/m. The block is at rest on a frictionless surface. A 10 g bullet is fired into the block, in the face opposite the spring, and sticks.

  Compute the starting torque and inserted rotor resistance

a three-phase,four pole,480 V,60 Hz,Y-connection slip-ring induction motor has the following parameters: R1=R'2=0.5 ohm ; X1+X'2=5 ohm. compute the starting torque and inserted rotor resistance that increases the starting torque by factor of 4.

  Find capacitance when relative permittivity of gasoline gave

A parallel plate capacitor has gasoline as the dielectric. The area of the plate is 0.25 m^2 and the distance between two plates is 5cm. a. Find the capacitance given that the relative permittivity of gasoline is 2.

  Find the location and the value of the third charger

Charges +Q and +3Q are seperated by a distance 2m. A third charge is located such that the electrostatic system is in equilibrium. Find the location and the value of the third charger in terms of Q.

  What is value of the feedback resistor require for amplifier

A pressure sensor covers a range of 0-500 psi with 2.5 mV/psi. The sensor is input to an ADC with a voltage range of 0 to 5 V. What is the value of the feedback resistor required for a non-inverting amplifier circuit required to interface the sens..

  How a transformer works

How a transformer works and apply those rules to a transformer where the primary core cross-sectional area is twice.

  Find the voltages of an autotransformer

A 120/240V single phase transformer is connected as an autotransformer. Suppose that V1 is 120V at zero degrees and the transformer is ideal. Find V2, I1, and I2.

  Find the minimum product-of-sums for the function

a) Using K-Map, find the minimum product-of-sums for the following function. Circle the term on the map and write the result in algebraic form. b) Draw the block diagram in NOR-NOR.

  Calculate the diode current

An ideal p-n junction diode has saturation current Is = 3e-15 A. Calculate the diode current.

  Find expressions for p and q from complex power

Let a series R-L-C network be connected to a source voltage V, drawing a current I. a) In terms of the load impedance Z=Z at angle of Z, find expressions for P and Q from complex power considerations.

  Determine what is the new cutoff frequency

A high-pass filter with C=30pF. R= 40 kohm A) What is the cutoff frequency The output of this filter is connected to an amplifier with an input resistance of 60 kohm. B) Sketch and label the new circuit. C) What is the new cutoff frequency

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd