Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An electrical circuit consists of a set of three parallel resistors (A,B, and C) which are connected in series with another set of two parallel resistors, (D and E).
These two sets of resistors are connected in a series loop to a battery.
Assume the following resistor values:
A=33 ohms
B= 100 ohms
C= 51 ohms
D= 22 ohms
E= 10 ohms
How much current could a 12 V battery drive through the circuit?
A. Less than 12 ohms?
B. Greater than 1 amp?
C. Less than 0.5 amps?
D. None of the above?
A shunt regulator utilizing a zener diode is biased on through a 100ohm resistor. Determine the change in the regulated output voltage for the two situations below a) VI changes +2.0 V, ILoad constant b) ILoad changes +100 mA, VI constan..
Design a circuit that takes the output from each of the five microphones your band uses and adds the voltage to create a single voltage signal which is fed to the amplifer. Except not all voltages should be equaly amplified.
A 440 Vrms (line to line voltage) three phase induction motor runs at 1150 rpm driving a load requiring 15Nm of torque. The line current is 3.4 at a power factor of 80% lagging. Find the input power in Kw, The output power in Kw, and the efficiency..
consider a random data paatern consisting of binary 1's and 0's , where the probability of obtaining either binary 1 or binary 0 is 2/3 and 1/3 respectively . calculate PSD for bipolar NRZ signaling .what is first null bandwidth of the signal.
Explain the following terms; (i) critical radius of insulation. (ii) economic lagging thickness.
an unknown semiconductor has Eg=1.1ev and Nv=Nc.it is doped with 10^15 donors,where the donor level is 0.2ev below Ec. given that Ef is 0.25ev below Ec, calculate ni and the concentration of electrons and holes in the semiconductor at 300k.
Determine the minimum signal to noise ratio (s/n) in dB required in each communication channel to achieve a data rate of 270 kbps?
Consider a 16-ary PSK system with symbol error probability PE = 10-5. A Gray code is used for the symbol to bit assignment. What is the approximate bit error probability
how to write a VHDL or an ABEL or a Verilog program using Active HDL 6.3 Student Edition or Xilinx Student Edition 6.31 for a generic 3-to-8 binary decoder with active-high inputs and outputs but with only a single enable input.
Given: The terminal pair of a hidden circuit has an open circuit voltage of 200 V. When a 50 k? resistor is placed across the terminal pair, a potential of 80 volts is observed. Required: Determine the terminal voltage that would result if the 50 k
A steam power plant employs a closed feedwater heater to improved the thermal efficiency. Draw a chematic and T-S diagram for the cycle, and labe it. Write an expression for the thermal efficienc of the ecycle in accordance with the labelling
A 4 to 20mA control signal is loaded by a 100Ohm resistor and must produce a 20 to 40V motor drive signal. Develop the equation relating the input current to the output voltage.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd