How many kwh energy would be generated per day

Assignment Help Electrical Engineering
Reference no: EM13289812

A solar pond consists of a thin layer of fresh water floating ontop of a denser later of salt water. When the salty layer absorbssun light, it becomes hot, to 140 degrees C. The ambient temp isassumed to be 20 degrees C.

a) what is the maximum efficiency (Carnot's efficiency) of aheat engine operating of the solar pond?

b) If a real engine is able to achieve 0.4 of the efficiency of theCarnot engine, how many kWh energy would be generated per day froma 10 m x 20 m pond that captures 50% of the 5.5 kWh/m2solar insolation in the area?

c) How many houses, each consuming 500 kWh per (30-day) month, canbe supported by a nearby salty reservoir of 500m x700m thatcaptures 75% of the 5.5 kWh/m2 solar insolation in thearea?

Reference no: EM13289812

Questions Cloud

Where the electric potential is zero : A -10.0 nC point charge and a +20.0 nC point charge are 15.0 cm apart on the x-axis. What is the direction of the electric field at the point on the x-axis, between the charges, where the electric potential is zero
Draw a timing diagram for all three clock signals : Given a 100 MHz clock signal, derive a circuit using D Flip Flops to generate 50 MHz and 25 MHz clock signals. Draw a timing diagram for all three clock signals, assuming reasonable delays.
Explain the calorimeter temperature increases : When a voltage of 30 V is applied to the heater for 3.0 min, a constant current of 2.5 A is observed. The calorimeter temperature increases from 20.00C to 25.59C. Calculate C_bomb for the calorimeter. Assume 2000.0 g of water in the bucket.
Describing brain lateralization and its role in language : Describing brain lateralization and its role in language.
How many kwh energy would be generated per day : A solar pond consists of a thin layer of fresh water floating ontop of a denser later of salt water. When the salty layer absorbssun light, it becomes hot, to 140 degrees C. The ambient temp isassumed to be 20 degrees C.
Explain radioactive isotope which decays with a half-life : Carbon-14 is a radioactive isotope which decays with a half-life of 5730 years. What is the first-order rate constant for its decay, in units of years^-1
Find the amount of the final sinking fund deposit : The total annual payments will be level at $3,300 until a final smaller annual payment suffices to pay off the loan. Find the amount of the final sinking fund deposit.
What is the limit on the leakage resitance for the capacitor : A 100-μF capacitor is initially charged to 100V. We want 90 percent of the internal energy to remain after one minute. What is the limit on the leakage resitance for the capacitor.
What velocity is required to cancel gravity : You want to practice zero g, i.e. not feeling any gravity. What velocity (ft/s) is required to cancel gravity at the top of the circle

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the baud rate for the multilevel system

A binary waveform of 53000 bits/sec is converted into an 8192 level waveform that is passed through a channel with a raised cosine-rolloff filter characteristic. The channel has a conditioned (equalized) phase response out to 4.0 kHz.

  Implement using d flipflops-and gates or gates and inverters

A sequential circuit for a luggage lock has 10 push buttons labeled0,1,2,3,4,5,6,7,8,9. Each pushbutton 0 through 9 produces a 1on X_i, i=0 through 9 with all other values on variable X_ j, jdoes not equal i, equal to 0.

  Find the internal induced voltage and torque angle

Find the input torque to the generator.If armature current and field current are kept constant, find the new value of the terminal voltage if the power factor is changed to 0.7 lagging.

  Design logic circuit for starting emergency diesel generator

design the logic circuit for starting an emergency diesel generator. For the generator to start, the generator must be disconnected from the bus, there must be sufficient starting air pressure, and the fuel tank must indicate there is oil.

  What is miller capacitance at the output of the amplifier

The feedback capacitance of an inverting amplifier is 10pF. What is the Miller capacitance at the input if the gain of the amplifier is -120 What is the Miller capacitance at the output of the amplifier

  Determine how many different layouts are possible

(a) If five different types of chips are to be placed on the board, how many different layouts are possible (b) If the five chips that are placed on the board are of the same type, how many different layouts are possible

  Determine the magnetizing current and the core-loss current

Sketch the appropriate equivalent circuit and phaser diagram and, assuming step-down operation, determine (a) the magnetizing current and the core-loss component of exciting current; (b) the exciting current; (c) the no-load power factor; (d) the ..

  Obtain a set of equations relating to symmetrical components

A three phase star connected load is connected across a three phase balanced supply system. Obtain a set of equations relating to symmetrical components of theline and phase voltages.

  Find the input power in kw and the efficiency in percent

A 440 Vrms (line to line voltage) three phase induction motor runs at 1150 rpm driving a load requiring 15Nm of torque. The line current is 3.4 at a power factor of 80% lagging. Find the input power in Kw, The output power in Kw, and the efficiency..

  Construct ladder schematic with holding circuit to energize

Construct a ladder schematic with a holding circuit to energize a relay. The relay when enerigized will turn one of and turn a different lamp on.

  Develop both the moore and mealy machines for an fsm

Draw a state diagram for an FSM that has an input X and an output Y. Whenever X changes from 0 to 1, Y should become 1 for two clock cycles and then return to 0, even if X is still 1. Develop both the Moore and Mealy machines.

  Design a digital thermometer system that can compensate

Design a digital thermometer system that can compensate for errors in the temperature sensing device's output T, which is an 8-bit input to the system. The compensation amount can be positive only and comes to the system as a 3-bit binary number

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd